OWNER SERVICE
Be familiar with all safety practices on pages 4 and
5.
aMake certain all movement of cutter compo- nents has stopped before opening blade access cover.
aAlways wear relatively Ulght and belted clothing to avoid entanglement In moving parts. Wear sturdy,
aOperate PTO at 2,000 rpm maximum.
aTurn tractor engine off, remove key, lower mower t o ground before performing any service or malntenance.
m Block mower securely before working
underneath.
aKeep all persons away from operator control area while performing adjustments, setvice or malntenance.
aMake sure tractor PTO
,3
LUBRICATION INFORMATION (figure 11)
Do not let excess grease collect on or around parts, particularly when operating in sandy areas.
The accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in operating hours, based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. Some reference numbers have more than one location; be sure you lubricate all locations.
Use a good quality SAE
Ref | . . | Freauencv |
M | Des- | |
1 | Front | 8 hrs |
2 | Drive Shaft Slip Joint | 8 hrs |
3 | Rear | a hrs |
4 | Drive Spindle | 24 hrs |
5 | Caster Arm | 8 hrs |
6 | Blade Spindle | 24 hrs |
7 | Caster Wheel (right & left) | 8 hrs |
|
|
|
Lubrication Chart
Figure 11. Lubrication Points
18 |
|