Assembling the Roof Studs and Braces
36
25
11*
11*^
11*
Note:
All Roof Studs
(11)marked with an asterisk (*) are assembled with one Short Bolt (59) in the slot above the Long Bolt(s) (60).
36
25
11*^
25
11^
11
11^
11
25
All Roof Studs (11) marked with a caret
(^) are assembled with two Long Bolts (60) in the slot.
All Roof Studs (11) not marked with a caret are assembled with only one Long Bolt (60) in the Slot.
Figure D
1.Attach all Roof Studs (11) to the outside of the Front/Rear Crown (15a, 15b). Leave the bottom ends of the Roof Studs unattached for now.
2.Slide one Short Bolt (59) into all the Roof Studs (11) marked with an asterisk (*) above. Slide two Long Bolts (60) into the Roof Studs indicated with a caret (^) above. Slide one Long Bolt (60) into all the Roof Studs not marked with a caret above. Secure the ends of all Roof Studs (11) to the outer top edge of the Side Ceiling Plates (20a, 20b) using Short Bolts (59).
3.Attach Roof Braces (25) to the underside of the Roof Studs (11)
4.Slide a Window Support Beam (36) onto two Roof Studs (11) marked with an aster- isk (*), with the predrilled holes on the underside and the flat side facing the Crown (15a, 15b). Use the extra Bolts (59) to secure the Beam loosely in place. Repeat for the other Window Support Beam (36).
5.At this time, verify that the Door Rail (28) is oriented correctly, with the rounded edge facing up – see number 4 on page 7.
SKU 93920 | For technical questions, please call | Page 12 |