Harbor Freight Tools 93920 manual Assembling the Studs and Braces, Figure C

5.Attach the Front-Center Top Stud (13) to the Front Crown Beams (2,3) using the

	Top-center Connector (39) as shown below right.	2	3
6.	Attach the Rear Crown Beams (4,5) to the Crown
	(15b) in the same fashion as the Front Crown Beams
	in step 2.
7.	Attach a Corner End Cap (68) onto the outer end of
	each Crown Beam (2-5). Cover the gaps between	13	39
	the Crown Beams (between 2-3 & 4-5) with a Peak
	Cap (72) in each. You may desire to use some silicone (not included) to secure
	the Peak Caps (72) in place.

8.With two assistants, lift the Crown Assembly and place the Crown Beams (2-5) on top of the Corner Brackets (26). (See Figure B.) Secure each corner in place with the Crown Beams on the outside of the Corner Brackets.

Assembling the Studs and Braces

The 13 spots requiring a

Hold-down Connector

(44)are marked with a plus (+).

	39
		9
	10
	8			12
			12*
		+		22
	+		+
P
TO
	+			+

	19
	56
	2
	63
	21
	19
	12*
12	22
+	21

12*	12
	22
+
Note:	+
All Side Studs

(12)with no asterisk are assembled using a Long Bolt (60) for the bottom connection.

19

12

P

TO

22	12*
+
	+

21

6

24

+

+	24
	7

+

All Side Studs (12) marked with an

asterisk (*) are assembled with one Long Bolt (60) in the middle of the slot.

Figure C

1.Attach the Rear-Left, Rear-Right, and Rear-Center Studs (8, 9, & 10) to the outside of the Rear Floor Plate (16) and Rear Brace (23). Slide a Hold-Down Connector

SKU 93920 For technical questions, please call 1-800-444-3353. Page