Installing the Transparent Panels
1.Panel Clips (67) are used to secure the Transparent Panels in place on the Green- house.
2.Remove the protective film from both sides of all panels.
48/50 | 15a/15b |
4848
3550
20a/20b
36
3.The Roof Panels (48) and the Roof Window Panel (50) will need to be placed as shown in the illustrations above. The top edges of these panels need to be placed up under the edge of the Crown (15a, 15b) or the Window Support Beam (36).
4.One at a time, place each Transparent Panel (47 – 49, 51 – 55) in its proper location on the Ceiling and Frame of the Greenhouse. Then, secure the Transparent Panel in place, using the quantity and location of Panel Clips (67) as shown in the Panel Installation Diagram, next page. Also, refer to the panel clip installation instructions in the following step.
5.Be careful, Panel Clip (67) ends may be sharp and may spring back! To attach Panel Clips:
a.Place the two loose ends of the Clip into the groove in the frame.
b.Swing the center portion of the Clip up against the panel.
c.Two edges of the Clip swing under the edge of the panel and the center edge holds the panel in place.
SKU 93920 | For technical questions, please call | Page 15 |