Servicing
To prevent serious injury
from accidental starting: Close the engine’s fuel valve, wait for the engine to cool, and disconnect the spark plug wire(s) before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury
from engine failure:
Do not use damaged engine. If abnormal noise, vibration, or excess smoking occurs, have the problem corrected before further use.
Maintenance Procedures
Many maintenance procedures, including those not detailed in this manual, will need to be performed by a qualified technician for safety. If you have any doubts about your ability to safely service the engine, have a qualified technician service the engine instead.
Note: Warranty is void if proper maintenance and servicing procedures are not followed.
Engine Oil Change
CAUTION! Oil is very hot during operation and can cause burns. Wait for engine to cool before changing oil.
Drain
Plug
1.Place a drain pan (not included) underneath the crankcase’s drain plug.
2.Remove the drain plug and, if possible, tilt the crankcase slightly to help drain the oil out. Recycle used oil.
3.Replace the drain plug (and gasket, if supplied) and tighten it.
4.Refill the oil to the proper level following the instructions under the Starting the Engine section.
Air Filter Element Maintenance
1.Wipe off the air cleaner cover.
2.The air cleaner cover is held in place by two knobs. Remove them.
3.Remove the air filter element.
4.Wash the element in warm water and mild detergent several times. Rinse. Squeeze out excess water and allow it to dry completely. Soak the filter in lightweight oil briefly, then squeeze out the excess oil.
5.Install the new filter or the cleaned filter.
Secure the Air Cleaner Cover before use.
SKU 96156 | For technical questions, please call | Page 11 |