Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before installation or use of this product.
|
|
|
| Engine Controls | |
Fuel Tank |
| Starter |
Cap |
| Handle |
Oil Fill
Brake
arm
Oil Fill - The oil fill cap has a dipstick attached. The crosshatch pattern at the bottom of the dipstick is the proper oil range. Before each use, check that the oil level is at the top of the cross hatched pattern, but not above that level.
Brake Arm - This must be held back to allow the engine to operate. It will force the engine to stop when released.
Starter Handle - This is pulled to start the engine.
Fuel
Valve
Choke Control
Fuel Valve - This controls the fuel supply to the engine.
The horizontal position is closed (off). The vertical position is open (on).
Choke Control - This controls the
The released position is open (run). The engaged position is closed (start).
Starting the Engine
Inspect engine looking for damaged, loose, and missing parts before installation and starting. If any problems are found, do not use engine until fixed properly.
Checking and Filling Engine Oil
CAUTION! Your Warranty is VOID if the engine’s crankcase is not properly filled with oil before each use. Before each use, check the oil level. Do not run the engine with low or no engine oil. Running the engine with no or low engine oil WILL permanently damage the engine.
1.Clean the top of the dipstick and the area around it. Remove the dipstick and wipe it off with a clean rag.
2.Reinsert the dipstick without threading it in and remove it to check the oil level.
|
| REV 10f |
Page 8 | For technical questions, please call | SKU 96156 |