Splitting Logs
This log splitter is ONLY designed to split wood with the grain direction. DO NOT attempt to split or crush wood against the grain, or split brick, concrete blocks, or rock. If you do, you will dam- age the machine, void the warranty, and possibly severely injure or kill bystanders or yourself.
To operate the log splitter:
1.Read and understand this entire manual and the Briggs & Stratton engine operators manual.
2.Verify that your job site location meets at least the minimum requirements for safety and use. Refer to Job Site Considerations on Page 16 for details.
3.Lower the rear landing leg and secure it in place with the lock pin.
4.Move the ram and beam assembly to the vertical position and lock it in place with safety chain shown in Figure 21.
5.Closely inspect all components and hydraulic lines for any evidence of damage, wear, or unsafe conditions; and correct before proceeding any further.
6.Put on your safety glasses, hearing protection, and thick leather gloves.
7.Start the engine, and place the log to be split in the splitting cradle.
8.Make sure bystanders are out of the work zone and the zone is clear of split lumber.
9.While keeping hands clear of the splitting wedge, use the control lever to split the log, retract the wedge, and remove the split log from the work zone.
Control Lever |
Splitter |
Wedge |
Splitting |
Cradle |
Work Zone is |
Approximately a |
Rear Landing Leg |
and Lock Pin |
Beam Safety Chain |
Figure 21. Log splitter positions.
Model G0639 |