15. Prepare the engine mounting plate by remov- ing any dirt, paint chips, or foreign material, and place the engine onto the pad shown in Figure 12.
Pad
18. Wrap the
Teflon Tape
Figure 12. Engine mounting pad.
16. Secure the engine with the four M8-1.25 x 45 hex bolts, flat washers, lock washers, and hex nuts as shown in Figure 13.
17. Tighten the fasteners in an alternating pat- tern evenly, so you do not risk cracking the mounting flange shown in Figure 13.
Mounting Flange and Hex Bolt
Figure 13. Installed engine.
Figure 14. Pressure fitting.
19. Wipe oil onto one of the 11 x 2.4mm O-rings and seat it into the O-ring seat in the end of the pressure fitting (Figure 14).
20. Remove the plastic cap from the pump pres- sure port and, add a couple of tablespoons of hydraulic oil into the pressure port (Figure 15).
21. Thread the Teflon tape end of the pressure fitting into this pump port, and tighten the fit- ting only until it is snug. DO NOT overtighten or you can crack the pump housing.
Figure 15. Pump pressure port.
22. Loosen the hose clamp, install the pump suc- tion hose onto the pump suction port (Figure 15), and tighten the hose clamp.
Model G0639 |