23. Using a screwdriver, unthread the plastic plug from the high pressure hose (Figure 16).
Control
Lever and
Cotter Pin
High
Pressure
Hose
29. Pull the tank vent cap (Figure 18) off, fill the hydraulic tank with 2.5 gallons of hydraulic oil, and reinstall the cap.
Tank
Vent /Fill
Cap
Figure 16. High pressure hose and control lever.
24. Install the high pressure hose onto the pump pressure fitting (Figure 16), making sure the O-ring stays in place.
25. Connect the control lever (Figure 16) to the control valve linkage with the clevis pin.
26. Remove the plastic cap from the tank return fitting (Figure 17), oil and install an 11 x 2.4mm O-ring on the end of the fitting.
27. Using a screwdriver, unthread the plastic plug from the low pressure return hose (Figure 17).
28. Install the low pressure return hose onto the tank return fitting (Figure 17), making sure the O-ring stays in place.
Low Pressure
Return Hose
Tank
Return
Fitting
Figure 17. Low pressure hose and tank fitting. -14-
Figure 18. Tank vent cap.
30. Refer to the Briggs & Stratton owner's manual to select your required oil type, locate the fill plug (Figure 19), and fill the engine with the required engine oil.