Generac Power Systems 04389-2, 04456-2, 04390-2 Specifications, ‹ 1.5.1 Generator, ‹ 1.5.2 Engine

Page 8

Section 1 — General Information

Guardian Air-cooled 7 kW, 12 kW and 15 kW Generators

1.5 SPECIFICATIONS

‹ 1.5.1 GENERATOR

 

 

Model 04389-2

 

Model 04456-2

Model 04390-2

Rated Max. Continuous Power Capacity (Watts*)

6,000 NG/7,000 LP

 

12,000 NG/12,000 LP

13,000 NG/15,000 LP†

Rated Voltage

120/240

 

120/240

120/240

Rated Max. Continuous Load Current (Amps)

 

 

 

 

 

120 Volts**

50.0 NG/58.3 LP

 

100.0 NG/100.0 LP

108.3 NG/125.0 LP

 

240 Volts

25.0 NG/29.2 LP

 

50.0 NG/50.0 LP

54.2 NG/62.5 LP

Main Line Circuit Breaker

30 Amp

 

50 Amp

60 Amp/70 Amp†

Phase

1

 

1

1

Number of Rotor Poles

2

 

2

2

Rated AC Frequency

60 Hz

 

60 Hz

60 Hz

Power Factor

1

 

1

1

Recommended Air Filter

Generac Part # C8127

Generac Part # C8127

Generac Part # C8127

Battery Requirement

Group 26/26R

 

Group 26/26R

Group 26/26R

 

 

12 Volts and

 

12 Volts and

12 Volts and

 

 

350 Cold-cranking

 

550 Cold-cranking

550 Cold-cranking

 

 

Amperes Minimum

 

Amperes Minimum

Amperes Minimum

Weight

452 Pounds

 

470 Pounds

487 Pounds

Output Sound Level @ 23 ft (7m) at full load

68 db (A)

 

70.5db (A)

71.5 db (A)

Normal Operating Range

 

-20°F (-28.8°C) to 104°F (40°C)

*Maximum wattage and current are subject to and limited by such factors as fuel Btu content, ambient temperature, altitude, engine power and condition, etc. Maximum power decreases about 3.5 percent for each 1,000 feet above sea level; and also will decrease about 1 percent for each 6° C (10° F) above 16° C (60° F) ambient temperature.

**Load current values shown for 120 volts are maximum TOTAL values for two separate circuits. The maximum current in each circuit must not exceed the value stated for 240 volts.

† 15,000 watt with upgrade kit 04578-1. Kit includes power harnesses and 70 amp 2-pole circuit breaker.

‹1.5.2 ENGINE

 

Model 04389-2

Model 04456-2

Model 04390-2

Type of Engine

GH-410

GT-990

GT-990

Number of Cylinders

1

2

2

Rated Horsepower

14.5 @ 3,600 rpm

26 @ 3,600 rpm

30 @ 3,600 rpm

Displacement

410cc

992cc

992cc

Cylinder Block

Aluminum w/Cast

Aluminum w/Cast

Aluminum w/Cast

 

Iron Sleeve

Iron Sleeve

Iron Sleeve

Valve Arrangement

Overhead Valves

Overhead Valves

Overhead Valves

Ignition System

Solid-state w/Magneto

Solid-state w/Magneto

Solid-state w/Magneto

Recommended Spark Plug

RC12YC

RC12YC

RC12YC

Spark Plug Gap

0.76 mm (0.030 inch)

0.508 mm (0.020 inch)

0.508 mm (0.020 inch)

Compression Ratio

8.6:1

9.5:1

9.5:1

Starter

12 Vdc

12 Vdc

12Vdc

Oil Capacity Including Filter

Approx. 1.5 Qts

Approx. 1.7 Qts

Approx. 1.7 Qts

Recommended Oil Filter

Generac Part # 70185

Generac Part # 70185

Generac Part # 70185

Recommended Air Filter

Generac Part # 0C8127

Generac Part # 0C8127

Generac Part # 0C8127

Operating RPM

3,600

3,600

3,600

6 Generac® Power Systems, Inc.

Image 8
Contents Installation Introduction Authorized Dealer LocationPost Installation Start-up Adjustments MaintenanceTroubleshooting Introduction Inside Front CoverGeneral Hazards Electrical Hazards ‹ Standards IndexBreaker for Bedrooms UNPACKING/INSPECTIONProtection Systems Generator 7 kW, Single Cylinder GH-410 Engine‹ 1.5.2 Engine Specifications‹ 1.5.1 Generator Reconfiguring the Fuel System System SET LEDFuel Requirements Recommendations Fuel ConsumptionTransfer Switch Location2 12KW and 15KW, 990CC Engines GeneratorBattery Installation BatteryElectrical Checks Check Transfer Switch OperationBefore Initial START-UP Generator Tests Under Load Checking Automatic OperationAdjusting the Regulator Natural GAS only Adjustment ScrewEngine Governor Adjustment Voltage Regulator Adjustment1 7 KW Units 2 12 KW and 15 KW UnitsBREAK-IN Procedure Automatic Transfer Operation‹ 3.2.1 Auto Position ‹ 3.2.2 OFF PositionManual Transfer Operation Sequence of Automatic OperationSetting the Exercise Timer ‹ 3.5.2 Transfer Back to Utility Power Source‹ 3.7.1 LOW OIL Pressure Switch ‹ 3.7.2 High Temperature Switch‹ 3.7.4 Overspeed Checking the Engine OIL LevelApproximate Crank Cycle Times ‹ 4.3.2 OIL Change Procedure Changing the Engine OILChanging the OIL Filter ‹ 4.3.1 Engine OIL RecommendationsBattery Maintenance Spark PlugsAdjusting GH-410/GT-990 Valve Clearance Cooling SystemOUT of Service Procedure ‹ 4.12.1 Removal from Service‹ 4.12.2 Return to Service Corrosion ProtectionService Schedule Be performed by the nearest Guardian Authorized DealerTroubleshooting Guide Problem Cause CorrectionElectrical Data Customer Battery Utility Battery Charger Utility Connection BCR SW1 Exploded Views and Parts Lists QTY Description Exploded Views and Parts Lists Circuit Breaker 40A X 2P Exploded Views and Parts Lists BOX GTS Load Center Exploded Views and Parts Lists COVER, 12 Position GTS Load Center 140 Sleeve Exploded Views and Parts Lists KNOB, AIR Cleaner 28 31 ADAPTOR, Engine Exploded Views and Parts Lists Stator 12KW Exploded Views and Parts Lists PIN, Piston D20 Exploded Views and Parts Lists SCREW, Taptite M6-1.0X8 Yellow Chrome Engine only Mounting Dimensions Guardian Air-cooled 7 kW, 12 kW and 15 kW Generators Guardian Air-cooled 7 kW, 12 kW and 15 kW Generators PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Control System Warranty Emission Related Parts Include the FollowingWarranty Schedule