Emerson CF220AGW00 Do not connect any neutral white, Required WAY WIRlNG Diagram NEW Construction

BP7360 JULIANNE 9/19/07 11:15 AM Page 14

!	WARNING				3. Before installing wall control, place wall
						control in “OFF” mode by pushing
Do not connect any neutral (white)						“ON/OFF” switch to the “OFF” position.
wire to this control. Incorrect wiring
will damage this control.						!	WARNING
					Do not connect any neutral (white)
4. Connect one black wire of wall control
to the “hot” wire. Securely connect					wire to this control. Incorrect wiring
					will damage this control.
wires with wire connectors supplied
(Figure 20).					4.	Install a	wall control in the wall box
5. Connect one black wire of wall switch
						containing the “hot” wire first. Connect
to the “load” (black) wire in wall box.
						the black wire of the wall control to the
Securely connect		wires with		wire
						“hot” wire. Securely connect wires with
connector supplied.
						wire connectors supplied.
6. Screw wall	control	into wall	box	and
					5.	Connect	one black wire of the wall
install decorator		style	faceplate
						control to both remaining traveler wires
(included). Leave wall control in “OFF”

mode until fan installation is completed.

in the wall box and secure with wire connector supplied.

7. Refer to page 5 and complete the ceiling fan installation.

NOTE: Retrofit 3-way installations are likely to include two traveler wires between the two wall boxes. In new construction, only one traveler wire Is

HI
	LIGHT
MED
LOW
FAN OFF
EMERSON		®
OFF	ON

Figure 20

BLK	T			HOT
	O
	1	2	0V			O		E
			AC		S		C
						UR

T
	O
BLACK	LOAD
			D
			N
			U
	G	R	O
FAN/LIGHT
			WALL
WALL
CONTROL			BOX

required.

3-WAY WIRlNG DIAGRAM: NEW CONSTRUCTION

HOT		FAN/LIGHT
		WALL
	EMERSON	CONTROL	EMERSON
BLACK		BLK	BLK
				LOAD
		TRAVELER

3-WAY INSTALLATION

(On fan controlled by two different wall controls) (See Figures 21 and 22.)

1. Disconnect power at circuit breaker or remove fuse.

2. At all wall box locations remove faceplates and screws from existing controls. Pull controls out from wall boxes and determine which wall box contains the “hot” lead and which wall box contains the “load” wire. Also, identify traveler wires which are common to both wall boxes. Disconnect wires from existing controls only. Do not attempt to disconnect any wires not already connected to existing controls.

NEUTRAL WIRE BLACK GROUND

REMOTE CONTROL

RECEIVER LOCATED

WITHIN THE CEILING

COVER

Figure 21

6.Place wall control into wall box. Screw in place and install decorator style faceplate (included).

7.Next, install the other wall control into the wall box containing the load wire. Connect the black wire of the wall control to the traveler wire(s) already connected to the black wire (in the other wall box). Secure with wire connectors supplied.

8.Connect one black wire of the wall control to the “load” (black) wire and secure with wire connector supplied.

14 U.L. Model No.: CF220