BP7360 JULIANNE 9/19/07 11:15 AM Page 9
SCROLL
COLLAR
SETSCREW 
GROMMET
COUPLING
COVER
MOTOR
HOUSING
Figure 9
SCROLL
RETAINING
SCREW
DOWNROD
SCROLL
DOWNROD
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
18. Place the ceiling cover over the downrod. Then reinstall the hanger ball (Figure 10) on the downrod as follows. Route the three 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
15. Unscrew the three scroll retaining screws from the scroll collar. Using the hex wrench (supplied), unscrew the setscrew in the scroll collar until it clears the inside of the collar. Slide the collar over the downrod (Figure 9), and position the collar 7 or 8- inches above the coupling cover, then tighten the setscrew.
PIN | HANGER BALL |
DOWNROD | SETSCREW |
16.Align one downrod scroll with one of the slots in the scroll collar and secure the scroll in place using a scroll retaining screw (previously removed) (Figure 9). Repeat this procedure for the remaining two downrod scrolls.
NOTE: The downrod scrolls must properly mate with the slots in the scroll collar to assure proper alignment. Securely tighten the screws.
17.Loosen the setscrew and slide the
scroll collar down the downrod until 
the decorative scrolls rest upon the top of the motor housing (Figure 9). Tighten the setscrew.
CEILING
COVER
Figure 10
19.The fan comes with blue, black and white leads that are 80” long. Before installing the fan, measure up approximately 6 to
20.You have now completed the initial assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.
9 | U.L. Model No.: CF220 |