Switch CUP Assembly | Emerson CF220GLZ00, CF220GBZ00, CF220AGW00

BP7360 JULIANNE 9/19/07 11:15 AM Page 7

8. Carefully rest the decorative ring/light fitter/switch cup assembly on the fan blades, then engage the connector of the switch cup assembly with the motor connector (Figure 4). The two connectors are keyed and color-coded and must be mated correctly (color-to- color) before they can be engaged. Make sure the connectors are engaged properly.

SWITCH CUP

ASSEMBLY

8-32 x 7mm PAN

HEAD SCREWS (3)

SWITCH CUP ASSEMBLY

Figure 5

MOTOR CONNECTOR

SWITCH CUP CONNECTOR

10. Position the top and bottom halves of the styrofoam packaging side-by-side on the floor with a six to eight inch gap between the halves (Figure 6). Carefully place the partially assembl- ed ceiling fan on the styrofoam halves, with the light fitter assembly positioned in the gap and the fan assembly resting on the decorative ring.

Figure 4	8-32 x 7mm PAN
	HEAD SCREW (2)

9.Partially install two 8-32 x 7mm pan head screws (supplied) in the outer rim of the switch cup plate (Figure 4). Engage the L-slots in the switch cup assembly with these screws; rotate the switch cup and tighten the two screws. Install another 8-32 x 7mm pan head screw in the remaining hole in the switch cup (Figure 5).

CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the switch cup plate and switch cup assembly.

STYROFOAM PACKAGING

Figure 6

PARTIALLY

ASSEMBLED FAN

6" - 8"

GAP

7	U.L. Model No.: CF220