Dynasty Spas SSPA-1 manual To start the pump, To turn the light on, Water heater automatic start

Page 1

SSPA-1 SPA PACK

Single-Pump System

This Quick Reference Card is a summary of your spa's main functions and provides a quick overview of operations accessible from your spa side keypad.

To start the pump:

Press the Pump key to turn the pump on at low speed. A second press will turn the pump to high speed. A third press will turn the pump off. A built-in timer will shut the pump off after 20 minutes unless it has been manually deactivated.

The "Pump" indicator light will be on when the Pump is running.

To turn the light on:

Press the Light key to turn the light on. A second press will turn the light off. A built-in timer will shut the light off after 2 hours unless it has been manually deactivated.

The "Light" indicator will be on when the light is on.

"Pump" indicator light

"Light" indicator

To change the water temperature:

"Heater" & "Set Point" indicator lights

Press the Up or Down arrow key to increase or decrease the desired water temperature. The selected temperature setting will be displayed for 5 seconds as a confirmation.

The "Set Point" indicator light indicates that the temperature shown is the desired, and not the current, temperature of the water!

The temperature can be adjusted in 1-degree increments from 59 to 104˚F (15 to 40˚C).

Water heater automatic start:

When the water temperature is 1˚F (0.5˚C) lower than the set point, the heater will be turned on automati- cally until the water temperature reaches the set point plus 1˚F (0.5˚C).

The "Heater" indicator light will be on when the heater is on.

Note: If your system is configured in Low Current Mode, the heater will not start if the pump is running at high speed.

Quick Reference Card

Image 1
Contents To start the pump Pump indicator light Light indicatorTo turn the light on Water heater automatic startDisplay is flashing Flashing dots are displayed