Dynasty Spas D-1000, D-2000 Spa Lights wont come on, Pump will not prime, Jets wont come on

Page 29

T r o u b l e S h o o t i n g G u i d e

No heat or heat too low

Probable Cause #1

Action

Probable Cause #2

Action

Probable Cause #3

Action

Probable Cause #4

Action

Dirty Filter

Clean Filter / Pull Filter and try running without filter

Breaker at house off.

Reset breaker at house. Breaker can appear to be on and one pole can be off. Turn breaker OFF then ON twice.

Pump not primed.

Refer to the section of this manual on pump priming

Improper line voltage.

Have a Licensed Electrician check the line voltage.

Spa Lights won't come on

Probable Cause #1 Action

Probable Cause #2 Action

Light bulb burnt out.

Replace bulb. (non-warranty)

Dirty connection

Check to see if there is anything covering the con- nection on the housing that holds the light bulb.

Pump will not prime

Probable Cause #1

Action

Probable Cause #2

Action

Probable Cause #3

Action

Probable Cause #4

Action

No water in pump

Make sure water level in spa is correct. Bleed top air bleed on face of pump till water flows out.

Closed gate valves or blocked lines.

Open all gate valves. Check suction for blockage

Pump surges, jets lose power, then comes back, then loses power again etc.

Check union on front or nose of pump to ensure tightness. Check drain plugs to ensure tightness.

Air lock

Bleed off air at air relief valve on pump.

Jets won't come on

Probable Cause #1

Action

Probable Cause #2

Action

Pump not primed.

Refer to the section of this manual on pump priming.

Gates Valves closed.

Check to see if gate valves are in the correct position. Check to see that pump is purged in.

29

Image 29
Contents Page Dealer InstallerDyynnaassttyy SSppaass Ownneerrss Maannuuaall Dear Dynasty Spa Owner P o r t a n t S a f e t y I n s t r u c t i o n s SPA & Pool Institute S i c I n t r o d u c t o r y I n f o r m a t i o n T u p & D e l i v e r y G u i d e l i n e s T u p & D e l i v e r y G u i d e l i n e s R i n g D i a g r a m Factory Recommended G.F.C.I Load Center WiringN e r a l P r e O p e r a t i o n I n s t r u c t i o n s To p S i d e C o n t r o l I n s t r u c t i o n s Freeze Protection Preset Filter CyclesDiagnostic Messages Preset Filter Cycles Auxiliary Panel optional System auxiliary panel optional Circulation Pump optional Standard and Economy ModeBlower optional LightEconomy StandardFlow IceMini Diverter Valve Dual Filter Lt e r L o c a t i o nSingle Filter Lt e r M a i n t e n a n c e Cleaning and Replacing Filter CartridgeFilling Spa With Water Cleaning Your Spa WaterBalance Water TestingAs Needed An Overview Monthly For Equipment ProtectionAlgae Control An Overview As NeededSkin Conditioning A i n i n g Yo u r S p a N t e r i z i n g Yo u r S p a Winterize Your SPAN t e r i z i n g S p a C o v e r s Ask Your Dealer About Using a Cover CaddyPump will not prime Spa Lights wont come onJets wont come on No heat or heat too lowSpa is leaking Low water flowMotor does not run Motor runs hotAir Blower Air Loop Air Venturi Cabinet O s s a r y o f T e r m sSkimmer O s s a r y o f T e r m s c o n tA M o d e l s D e t a i l R e f e r e n c e C h a r t