Echo PPT-280 specifications Lubricating the Guide Bar and Saw Chain, Automatic Oiling System

Page 19

PPT-280

OPERATION

 

 

Storage - Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, airtight container. Store in a well-ventilated, unoccupied building, away from sparks and flames.

Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added.

Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.

Lubricating the Guide Bar and Saw Chain

Automatic Oiling System

1.Wipe debris from around oil fill cap.

2.Remove oil fill cap and fill reservoir with a quality, low viscosity guide bar and saw chain oil.

To prevent plastic deterioration, do not use synthetic or silicone based oil

Adjusting Automatic Oiler

1.From bottom of gear case, turn adjustment screw (A) clockwise to decrease oil volume - counter clockwise to increase oil volume

Note: The automatic oiler is preset to deliver a sufficient oil discharge volume during normal operating conditions. During heavy or dry cutting conditions, the oil discharge volume may be increased to assure adequate lubrication. If oil is leaking from the bar cover area, reduce the oil discharge volume. Refill the oil reservoir with each tank of fuel..

A

Note: Very little visible oil on the saw chain will provide sufficient lubrication.

X7702091009

19

© 02/2014 ECHO Inc.

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Burn Hazard Operator’s ManualTable of Contents Servicing Information IntroductionIntroduction Manual Safety Symbols and Important Information SafetySafety Additional or Replacement ManualsMixture International SymbolsPersonal Condition and Safety Equipment Repetitive Stress Injuries Vibration and ColdKeep a Firm Grip Read the ManualsClear the Work Area Use Proper Clothing & EquipmentEquipment KickbackGuide Bar and Saw Chain Product Emission Durability Emission Compliance Period Emission Control Exhaust & EvaporativeEmission Control Exhaust & Evaporative EPA 2010 and Later and/or C.A.R.B. TierDescription Description Contents Drive Shaft/Power Head AssemblyAssembly Drive Shaft/Handle AssemblyAssembly Cutting Attachment to Drive Shaft InstallationTo Adjust Saw Chain Tension Saw Chain Tension AdjustmentFuel Requirements OperationOperation FuelAfter use Handling FuelLubricating the Guide Bar and Saw Chain Adjusting Automatic OilerAutomatic Oiling System Purge Bulb Starting Cold EngineStopping Engine Starting Warm EnginePruning Techniques Skill Levels MaintenanceMaintenance Maintenance IntervalsFuel Filter Air FilterCooling System Spark PlugSpark Arrestor Screen Exhaust SystemHigh Altitude Operation Carburetor AdjustmentExhaust Port Cleaning Engine Break-InLubrication MAINTENANCEPPT-280Flexible Drive Shaft Guide Bar Replacement / Installation Guide Bar and Saw Chain ReplacementSprocket Guard Cleaning BAR P/N Chain P/N Chain Type Links Pitch Guage Filing Standard Saw ChainTop Plate Angle Troubleshooting TroubleshootingStorage StorageLong Term Storage Over 30 Days Specifications SpecificationsOWNER’S Responsibility Warranty StatementsPurchased Repair PARTS, Short Blocks and Accessories Warranty StatementsPPT-280 PPT-280 PPT-280 ECHO, Incorporated
Top Page Image Contents