MAINTENANCE | |
|
|
Note: Federal EPA regulations require all model year 2012 and later gasoline powered engines produced for sale in the United States to be equipped with a special low permeation fuel supply hose between the carburetor and fuel tank. When servicing model year 2012 and later equipment, only fuel supply hoses certified by EPA can be used to replace the original equipment supply hose. Fines up to $37,500 may be enforced for using an
Spark Plug
Level 2.
Parts Required: REPOWERTM
Use only NGK
1.Remove spark plug and check for fouling, worn and rounded center electrode.
.65 mm (.026 in.)
2.Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine.
3.Adjust spark plug gap by bending outer electrode.
4.Tighten spark plug to
Cooling System
Level 2.
Parts Required: None if you are careful.
To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the cylinder.
•Dust and grass build up on the outside of the cylinder. This build up insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance.” Any failure attributed to lack of maintenance is not warranted.
X7702091009 | 25 |
© 02/2014 ECHO Inc.