6.4.2 Requirements to perform the test | 6.5.1 Description |
Working keyboard to cycle through the tests and to start up the test.
Working local display to check the output messages.
6.4.3Description of the tests
Focus control test
The focussing lens is continuously moving up and down. The display reads "BUSY".
Sledge control test
After pressing [F FWD] the sledge continuously moves up and down. Pressing [REWIND] stops the sledge at the position it is in and the focus control test resumes. The display reads "BUSY".
Tray control test
This test starts from within the focus control test routine. Pressing [OPEN/CLOSE] moves the tray in or out. In the tray open position one can initiate focus and sledge tests by pressing [F FWD]. One has to stop these tests pressing [REWIND] before it is possible to close the tray again. Depending on the action the display reads "OPEN", "OPENED", "CLOSE" or "BUSY".
6.5DC-erase service mode
DC ERASE SERVICE MODE
(erasement of complete CD-RW)
This test is initiated by pressing [ERASE] and [RECORD] simultaneously while switching on the unit. The player will erase a complete
6.5.2Requirements to perform the test
Functional CDR player.
A
Load
Press
<ERASE> + <RECORD>
simultaneously and switch ON unit
Display shows:
“ER mm:ss”
mm:remaining minutes
ss :remaining seconds
TOTAL and REM are also illuminated
Display shows:
“PASSED”
when the erase function is completed
“ERROR”
if DC ERASE fails
To end test, switch OFF unit
CL96532086_027.eps 080999
Figure
9