8.1.3Display board troubleshooting guide
SWITCH POWER ON,
EXIT STAND BY
MODE
NO
DISPLAY?
YES
CHECK :
SUPPLY VOLTAGES
3V8 ± 10% between conn.
CLOCK SIGNAL
8Mhz at pins 8, 9 of QY01
CONTROL SIGNALS
RESETN 3V3 (high) at conn.
I2C CLK at conn.
FTD DRIVE LINES
Filament voltage 3V8 10% between pins
Grid lines (see test instructions) Segment lines (see test instructions)
ELECTRICAL SERVICE DIAGNOSTICS - Local display test
KEYNO FUNCTIONS?
YES
REMOTE NO CONTROL?
YES
DISPLAY BOARD
OK
CHECK:
KEY MATRIX LINES (see test instructions)
ELECTRICAL SERVICE DIAGNOSTICS – Keyboard test
EASY JOG KNOB (see test instructions)
CHECK:
IR RECEIVER signal at pin 22 of QY01 ( see test instructions) ELECTRICAL SERVICE DIAGNOSTICS – Remote control est
CL 96532076_020.eps 290799
Figure 8-9 Display board troubleshooting’
19