Echo PB-760 LN H/T specifications Long Term Storage Over 30 Days

Page 30

STORAGE

PB-760 LN H/T

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6 -7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

9.Remove blower pipe assembly from unit.

30

X7531125002

© 03/2013 ECHO Inc.

Image 30
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationSafety Manual Safety Symbols and Important InformationInternational Symbols Personal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment Emission Control Exhaust & Evaporative EPA 2010 and Later and/or C.A.R.B. TierProduct Emission Durability Emission Compliance Period Description PB-760 LN HDescription PB-760 LN T Description Contents Assembly Install Blower Pipes/Stick HandleInstall Blower Pipes AssemblyX7531125002 Fuel Requirements OperationFuel Handling FuelOperation Starting Cold Engine PB-760 LN H and TStarting Warm Engine Stopping EngineRead the Safety Section carefully Operating BlowerCold Weather Operation Maintenance Maintenance IntervalsSkill Levels Air Filter Fuel FilterCleaning Grill Spark PlugCooling System Cleaning Cylinder Fins Exhaust SystemSpark Arrestor Screen Engine Break-In Carburetor AdjustmentExhaust Port Cleaning High Altitude OperationIdle Adjustment Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements OWNER’S ResponsibilityWarranty Statements PB-760 LN H/T PB-760 LN H/T