Echo PB-760 LN H/T specifications Install Blower Pipes, Assembly

PB-760 LN H/T ASSEMBLY

PB-760 LN T

Never perform maintenance or assembly procedures with engine running or serious personal injury may result.

Install Blower Pipes

1.Place guide loop (G) across clamp, and turn until clip fully engages clamp band.

Note: Clamp with cable guide loop (G) fits elbow end of flexible pipe (B).

2.Assemble clamps (A) onto both ends of flexible pipe (B).

3.Assemble swivel pipe (C) into flexible pipe (B) and tighten clamp (A).

Note: Hang handle freely from blower to assure throttle cable is not twisted before installing handle (E).

4.Loosen knob (H) on handle (E). Align notch in handle with tabs (F). Install onto swivel pipe (C) past long ridges in pipe.

5.Assemble flexible pipe (B) to elbow (D) on blower. Position guide loop (G) on outside of flexible pipe (away from blower) and tighten clamp (A).

X7531125002

		G	G
G	B	A	C
A
			E
			H
		C
			F
			A
D			B
	G
			15

© 03/2013 ECHO Inc.