SPECIFICATIONS
|
| Model ZTR 3362 |
CHASSIS: | The monocoque design chassis of the 3000 Series Models incorporates CNC | |
| Laser and CNC brake processes to form the twin 12 gauge side frames and 7 | |
| gauge transmission and engine base plate. | |
BODY: | All body parts are made of rotational molded polyethylene. Front body contains | |
| access panel for battery service. Seat tilts forward to allow transmission service. | |
MOWER DECK: | 11 GA stamped steel construction. | |
| 36" Cut width. Cut height approximately 1" to 4" via 7 position lift | |
| handle. |
|
BLADE DRIVE: | Electric clutch. | |
TRANSMISSION: | Each rear wheel is independently driven by chain and sprockets through a friction | |
| mechanical drive. | |
ENGINE: | 13 HP Briggs & Stratton Diamond Plus, | |
| Gasoline, Vertical Shaft, Cast Iron Cylinder, | |
| Shroud. |
|
STARTING SYSTEM: | Electric by key switch operation with safety interlocks on parking brake and blade | |
| drive. |
|
TIRES: | Front | 410 X 3.50 X 4 ribbed tread. |
| Rear | 18 X 8.50 X 8 Multi Trac tread. |
CAPACITIES: | Fuel - 2.0 gallons total. | |
| Engine: 1.25 quarts oil. | |
DIMENSIONS: | Width | 43.0" outside rear wheel measurement. |
| Height | 36.0" to top edge of seat. |
| Length | 65.5" hitch tab to front bumper. |
| Weight | 500 lbs. |
NOTE: | Additional information provided in service instructions under the individual | |
| component. | |
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
Page 10