CARE AND MAINTENANCE
STEERING CONTROL ADJUSTMENTS (continued):
To adjust “IN” position of the steering controls:
1.Remove the two front bolts, lockwashers, and washers which hold the fender cap.
2.Pull the boot from the hole in the fender cap, exposing the cast iron lever.
3.Using a 5/32” Allen wrench, turn the setscrew to adjust the stop.
4.Replace the boot into the hole in the fender cap.
5.Replace the two front bolts, lockwashers and washers.
To align handles:
Sit on the seat and push the control levers full forward and full backward. If the ends do not match, the handles may be adjusted as follows:
1.Locate setscrew stops in the steering control lever base which stop the lever in each direction.
Note: The one at the rear is the stop for forwad and the one in the front is the stop for reverse.
2.Adjust setscrew stops so that handles line up together when shifted full forward and full reverse.
34