Dixon D25K48YT Transmission, To Replace Headlight Bulb, Interlocks And Relays, To Replace Fuse

Page 25

TO REPLACE HEADLIGHT BULB

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 44)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

02491

Fig. 44

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperatingthetractor. See“PURGETRANSMISSION” in the Operation section of this manual.

25

Image 25

Contents D25K48YT Operators ManualSafe Operation Practices for Ride-OnMowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING GENERAL SERVICEPRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES SERVICE AND ADJUSTMENTSMower UNASSEMBLED PARTSMower Front Wheel Slope SheetTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYTO CHECK BATTERY See Fig ADJUST SEAT See FigASSEMBLY Fig. 8 ATTACH FRONT LINK E See Fig 7. ATTACH REAR LIFT LINKS C See FigCHECK DECK LEVELNESS CHECK TIRE PRESSURECHECK FOR PROPER POSITION OF ALL BELTS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR TO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORSTOPPING See Fig TO USE THROTTLE CONTROL D See FigTO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigK J L TO USE CRUISE CONTROL J See FigBEFORE STARTING THE ENGINE SERVICE REMINDER/HOUR METERREVERSE OPERATION SYSTEM ROS TO OPERATE ON HILLSPURGE TRANSMISSION TO START ENGINE See FigMOWING TIPS MAINTENANCE MAINTENANCEGENERAL RECOMMENDATIONS SCHEDULETRACTOR BATTERYBLADE CARE BLADE REMOVAL See FigCLEAN AIR SCREEN TRANSAXLE MAINTENANCEENGINE V-BELTSIN-LINEFUEL FILTER See Fig CLEANINGDECK WASHOUT PORT See Fig PluganyholesinmowerwithboltsandlocknutsTO INSTALL MOWER SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig TO REPLACE MOWER BLADE DRIVE BELT See FigTO LEVEL MOWER TO CHECK BRAKE TO REPLACE MOTION DRIVE BELT See FigFRONT WHEEL TOE-IN/CAMBER TO REMOVE WHEEL See FigREPLACING BATTERY See Fig TO START ENGINE WITH A WEAK BATTERY See FigTO ADJUST THROTTLE CONTROL CABLE TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO ADJUST CHOKE CONTROL TO ADJUST CARBURETOROTHER STORAGEFUEL SYSTEM ENGINE OILPROBLEM TROUBLESHOOTINGLoss of power CAUSEBattery will not to run when operfires” when turn Engine continues15 DEGREES MAX ONLY RIDE UP AND DOWN HILL NOT ACROSS HILLLIMITED WARRANTY