Dixon D25K48YT, 435068 manual Assembly

Page 7

Manual background

ASSEMBLY

LIFT

LEVER

Fig. 4

2.ASSEMBLE FRONT GAUGE WHEEL (W) TO FRONT OF MOWER (See Fig. 5)

4. SLIDE MOWER UNDER TRACTOR (See Fig. 8)

•Bring belt forward and check belt for proper routing in all mower pulley grooves.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

Q

H

W

X

Z

Y

H.FRONT MOWER BRACKET

W. FRONT GAUGE WHEEL

X.SHOULDER BOLT

Y.1-1/4 O.D.

WASHER

Z.3/8-16 LOCKNUT

	A	A. MOWER SIDE
	A	SUSPENSION
		SUSPENSION
		ARMS

Fig. 5

3.TURN STEERING WHEEL LEFT AND POSITION MOWER (See Fig. 6)

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield (Q) to the right.

	Q. DEFLECTOR
02965	SHIELD
	SHIELD

Fig. 8

5.INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 9 - 11)

FRONT

Q

ENGINE

TRANSAXLE

Q. DEFLECTOR

BACK02965SHIELD

Fig. 6

ANTI-SWAY BAR (S)
TOWARDS	TOWARDS
TRANSAXLE	MOWER DECK
90° END	INTEGRATED WASHER END

Fig. 9

•From right side of mower, first insert 90° end of anti-sway bar (S) into hole in transaxle bracket (T), located near left rear tire in front of transaxle.

NOTE: Flashlight may be helpful.

K

C

I

	M	F		A. MOWER SIDE SUSPENSION
L B	M
L B
				ARMS
			W	B. RETAINER SPRING
	A		W	C. REAR LIFT LINK(S)
	A			C. REAR LIFT LINK(S)
		E		D. RIGHT SIDE REAR MOWER
		E		BRACKET
				E. FRONT LIFT LINK ASSEMBLY
				F. FRONT SUSPENSION BRACKET
				H. FRONT MOWER BRACKET
			H	I. LEFT SIDE REAR MOWER
				BRACKET
				K. BELT TENSION ROD
				L. LOCKING BRACKET
				M. ENGINE CLUTCH PULLEY
				Q. DEFLECTOR SHIELD
C				S. ANTI-SWAY BAR
S	D			W. FRONT GAUGE WHEEL
S	D		Q

Fig. 7

7

Image 7

Contents D25K48YT Operators ManualII. SLOPE OPERATION SAFETY RULESSafe Operation Practices for Ride-OnMowers I. GENERAL OPERATIONGENERAL SERVICE V. SERVICEIII. CHILDREN IV. TOWINGSERVICE AND ADJUSTMENTS TABLE OF CONTENTSPRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESSlope Sheet UNASSEMBLED PARTSMower Mower Front WheelADJUST SEAT See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO CHECK BATTERY See FigASSEMBLY Fig. 8 ATTACH FRONT LINK E See Fig 7. ATTACH REAR LIFT LINKS C See FigCHECK BRAKE SYSTEM CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR TO USE THROTTLE CONTROL D See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig STOPPING See FigTO USE CRUISE CONTROL J See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig K J LTO OPERATE ON HILLS SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE REVERSE OPERATION SYSTEM ROSPURGE TRANSMISSION TO START ENGINE See FigMOWING TIPS SCHEDULE MAINTENANCEMAINTENANCE GENERAL RECOMMENDATIONSBLADE REMOVAL See Fig BATTERYTRACTOR BLADE CAREV-BELTS TRANSAXLE MAINTENANCECLEAN AIR SCREEN ENGINEPluganyholesinmowerwithboltsandlocknuts CLEANINGIN-LINEFUEL FILTER See Fig DECK WASHOUT PORT See FigTO REPLACE MOWER BLADE DRIVE BELT See Fig SERVICE AND ADJUSTMENTSTO INSTALL MOWER TO REMOVE MOWER See FigTO LEVEL MOWER TO REMOVE WHEEL See Fig TO REPLACE MOTION DRIVE BELT See FigTO CHECK BRAKE FRONT WHEEL TOE-IN/CAMBERREPLACING BATTERY See Fig TO START ENGINE WITH A WEAK BATTERY See FigTO ADJUST CARBURETOR TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO ADJUST THROTTLE CONTROL CABLE TO ADJUST CHOKE CONTROLENGINE OIL STORAGEOTHER FUEL SYSTEMCAUSE TROUBLESHOOTINGPROBLEM Loss of powerEngine continues to run when operBattery will not fires” when turn15 DEGREES MAX ONLY RIDE UP AND DOWN HILL NOT ACROSS HILLLIMITED WARRANTY