Dixon 6601 Series manual Parking Brake Cable Adjustment

Page 31

CARE AND MAINTENANCE

PARKING BRAKE CABLE ADJUSTMENT:

Position parking brake lever in the off or disengaged position.

This will allow the belt idler used on the engine to T-box to swing fully and apply tension to the belt.

At this time, check that the cable which pulls the idler to a neutral position has approximately 1-1/2 to 2 inches of free play.

If adjustment is required, loosen the lock nuts on the cable block and turn cable sleeve in or out to achieve desired measurement.

Re-tighten lock nuts.

NOTE: Cable must have the above dimension with parking brake released or drive belt may slip, causing loss of power.

Page 28

Image 31

Contents Page Important Read Carefully Index Safety Safety Alert Symbol Safety SymbolsSafety Do not Children Service Dixon Limited Warranty Policy -- HYDRO-GEAR Models Specifications Seat Adjustment Instructions Controls To SET Parking Brake Parking BrakeHYDRO-GEAR Drive System Braking To GO ForwardTo GO Backward TurningMower Deck CUT Height Lift Lever Circuit BreakerBlade Drive Operation Instructions Operation Instructions Starting Instructions Cold Engine Always turn engine off when leaving mower Grass Height Suggestions Maintenance Schedule Care and MaintenanceCutter Blade Maintenance Belt Tension Lubrication Fuel Shut OFF ValveFeel uneasy on it, do not mow it Rear WheelsImportant Protect your investment OIL Fill Changing the Engine OILProtect Your Investment Deck Leveling and Height Adjusting Procedure Drive System Adjustments Parking Brake Cable Adjustment Neutral Adjustment Forward Travel Speed Adjustments AIR GAP Adjustment Procedure for Electric Clutch AdjustmentOhms Test Hydrostatic Transmission OIL and Filter Service Care and Maintenance Kohler AIR and OIL Filter Part Numbers Model ZTRSituation Causes Remedy Mower CUT QualityDrive System TroubleshootingElectrical System Page Page Page Page Page Page Page Page Information September