Specifications

CHASSIS:

BODY:

SEAT:

MOWER DECK:

BLADE DRIVE: DRIVE SYSTEM:

ENGINE:

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE:

CAPACITIES:

DIMENSIONS:

NOTE:

Model ZTR 6601

1 1 GA - rectangular tube

Two piece - made of rotational molded polyethylene. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

Economically designed for operator comfort by use of high density closed cell foam, contoured back rest and arm rests. Seat is adjustable fore and aft.

1 0 GA stamped steel construction 3 blades combine for 60" cut width Cut height approximately 1" to 4.5" via 8 position lift handle

Electric clutch

Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear gearbox.

22 HP Kohler Command, 4-Cycle, Twin Cylinder, V-Configuration, Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head and Crankcase with Cast Iron Liners, Oil Cooler.

Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Front	1 1 X 4 X 5 Ribbed Tread
Rear	20 X 1 1 X 8 Turf Tamer AT.
Front	16-21lbs. Rear	5

Ibs. maximum pressure

Fuel - 4.8 gallons total (dual tanks) Hydrostat oil tank - 3 quart with in-line 10 micron filter Hydrostat oil recommendation, refer to page 29 Engine - 2 qts. SAE 1 0W30 (with filter)

Width	72"
Height	45"
Length	89"
Weight	700 Ibs.

Additional information provided in service instructions underthe individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 8