Dixon 6601 Series manual Cutter Blade Maintenance

Page 23

CARE AND MAINTENANCE

CUTTER BLADE MAINTENANCE:

NOTE: Observe proper blade position prior to removal.

1.Safely raise front of mower.

2.Hold or block blade from turning.

CAUTION	Wear heavy, thick gloves when holding onto cutter blade,
	avoid the sharp edge of the blade.

NOTE: Be sure blade is centered on pilot before tightening bolt to 60 ft. Ibs. torque.

BLADE

SHAFT

MOWE

R

PILOT HUB SHOULD BE

SEATED INSIDE BLADE

Page 20

Image 23

Contents Page Important Read Carefully Index Safety Safety Alert Symbol Safety SymbolsSafety Do not Children Service Dixon Limited Warranty Policy -- HYDRO-GEAR Models Specifications Seat Adjustment Instructions Controls HYDRO-GEAR Drive System Parking BrakeTo SET Parking Brake Braking To GO ForwardTo GO Backward TurningBlade Drive Circuit BreakerMower Deck CUT Height Lift Lever Operation Instructions Operation Instructions Starting Instructions Cold Engine Always turn engine off when leaving mower Grass Height Suggestions Maintenance Schedule Care and MaintenanceCutter Blade Maintenance Belt Tension Lubrication Fuel Shut OFF ValveFeel uneasy on it, do not mow it Rear WheelsImportant Protect your investment Protect Your Investment Changing the Engine OILOIL Fill Deck Leveling and Height Adjusting Procedure Drive System Adjustments Parking Brake Cable Adjustment Neutral Adjustment Forward Travel Speed Adjustments Ohms Test Procedure for Electric Clutch AdjustmentAIR GAP Adjustment Hydrostatic Transmission OIL and Filter Service Care and Maintenance Kohler AIR and OIL Filter Part Numbers Model ZTRSituation Causes Remedy Mower CUT QualityDrive System TroubleshootingElectrical System Page Page Page Page Page Page Page Page Information September