Dixon 13089-0601 manual Specifications

	SPECIFICATIONS
		Model ZTR 5020
CHASSIS:	11 GA - rectangular tube
BODY:	Two piece-made of rotational molded polyethylene. Front
	body contains access panels for battery service & engine
	to mower deck belt removal. Rear body tilts up to allow
	service on the entire drive system.
SEAT:	Designed for operator comfort by use of high-density
	closed cell foam padded back rest and arm rests,
	upholstered with CorduraTM water-repellent fabric. Seat
	is adjustable fore and aft.
MOWER DECK:	Two decks are available. The 60” is made of stamped
	steel. The 50” is made of 11 GA fabricated welded
	construction with external reinforcement ribs. Three
	blades combine for either a 50” or 60” cut width. Cut
	height approximately 1.5” to 4.5” via 7 position lift handle.
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear
	BDU-10L Series 70 hydrostatic transmission. The hydrostatic
	transmissions power a fully enclosed HydroGear gearbox.
ENGINE:	20HP Briggs & Stratton ELS, overhead valves, replaceable
	oil filter, full pressure lube system, dual element air cleaner,
	integral fuel pump.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on
	parking brake and blade drive clutch.
TIRES:	Front	11 X 4-5 ribbed tread
	Rear	20 X 10-8 Multi-Trac
RECOMMENDED	Front	16 - 21 lbs.
TIRE PRESSURE:	Rear	8 - 14 lbs.
CAPACITIES:	Fuel - 4.8 gallons total (dual tanks)
	Oil tank - 3 quart with in-line 40 micron filter
	Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS:	Width	60” (50” Deck), 73” (60” Deck)
	Height	45”
	Length	72:
	Weight	668 lbs, (50” Deck, 685 lbs (60” Deck)

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

13