CARE AND MAINTENANCE
NEUTRAL ADJUSTMENT:
1.Engage parking brake and raise rear of frame with jack or blocks so that rear tires do not contact the ground.
2.Swing out the control levers, start the engine, and release the paking brake.
3.Raise the upper body to access hydro control linkage. If right wheel creeps, adjust right side linkage and
a.loosen, but do not remove, the bolt in the control tube (5540)
b.loosen jam nuts on ends of the control rod (9067)
c.turn control rod in or out until neutral
is achieved
d.tighten jam nuts on control rod
e.tighten bolt in control tube
9067 CONTROL ROD ADJUST IN STEP C
5540 CONTROL
TUBE
JAM NUTS LOOSEN IN
STEP B TIGHTEN IN STEP
D
CONTROL TUBE BOLT
LOOSEN IN STEP A
TIGHTEN IN STEP E
50