Heat Status Light
Dimension One Spas ICON (Logo)→
Infrared Sensor
2004 Bay Collection
Owner’s Manual
The Heat Status Light will turn on when there is a call for heat and the heater engages. This is a normal function. The right side of the Digital Display Window will continue to read the current temperature while the bottom left corner will scroll the message “HEATING TO _ _ _° F” until the hot tub reaches the set temperature. An animated thermometer will also be displayed in the upper center of the Digital Display Window to confirm heater activity.
If the water reaches 2° F (≅1° C) above the set temperature, the message
“COOLING TO _ _ _ - CIRC PUMP & O3 OFF” will be displayed in the bottom left hand side of the Digital Display Window and a cooling cycle will start.
The time of day can be viewed by pushing the Dimension One Spas ICON→- logo on the far right of the control panel. If no other button is pushed within 5 seconds, the display will revert to the hot tub water temperature reading. The
Pressing the logo for 5 seconds will place the spa in the “Standby” mode and allow the spa to be cleaned without turning off the power.
The Top Side Control also offers a
To use it, simply point the D1 Remote Control at the infrared sensor and press the appropriate button on the remote control. The infrared sensor is the located between the Water Feature and Up buttons.
28