Desa Td101, Td103, Td109, Td111 owner manual Operation, Checking for leaks, Lighting instructions

Page 9

Operation

Use only a 20 lb. propane/LP cylinder (not included). See safety information for proper cylinder selection. Connect hose/regulator assembly to propane cylinder (see Figure 12). Hose should already be connected to heater. When connecting regulator assembly to cylinder valve, hand tighten nut clockwise to a positive stop. DO NOT use a wrench to tighten. Use of a wrench may damage quick closing coupling nuts and result in a hazard- ous condition.

Route retention chain through at least one handle of propane/LP tank (see Figure 12). Make sure to route chain through handle on tank and NOT around tank valve. Chain must not interfere with valve. Attach hooks on both ends of chains to ring retainers installed on burner support plate. See Figure 7, page 6.

Retention

Chain

Hose/Regulator

Assembly

20 lb.

Propane/LP

Cylinder

Figure 12 - Connecting Hose/Regulator

Assembly to Propane/LP Cylinder

Checking for leaks

1.Turn heater valve to OFF position.

2.Turn cylinder supply valve fully counter clockwise to OPEN position.

3.Use a noncorrosive leak detection solution to check the connection. For leaks before attempting to light heater. If leak is found, turn cylinder valve to CLOSE and do not use until all leaks are corrected.

Lighting instructions

1.Push heater control knob in and turn coun- ter clockwise to the START position.

2.Push knob in and press IGNITOR button. Repeat until heater is lit.

3.Continue holding knob in for approxi- mately 30 seconds. Heater should remain lit in the LOW heat setting.

4.For more heat, press knob and rotate counterclockwise to HIGH setting.

5.If RELIGHTING, wait 5 minutes for heater to cool and gas to clear, then follow steps 1 through 3.

HIGH

START-LOW

IGNITOR

OFF

Figure 13 - Heater Controls

Shutdown Instructions

1.Press control knob and rotate clockwise to OFF position.

2.Close propane/LP cylinder valve (rotate knob clockwise).

BURNER OPERATION

Visually inspect burner for proper operation. A correct burner pattern shows blue fames with some yellow tipping and top half of emit- ter glows red.

An incorrect burner pattern shows large fames more than half the height of emitter coming outside of emitter. Flame should stay contained inside emitter.

 

Correct

Incorrect

 

 

Burner Pattern

Burner Pattern

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 14 - Burner Operation

118992-01Fwww.desatech.com

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Model No Located on side panel Serial No Date of Purchase If odor continues, immedi- ately call your gas supplierSafety Information Table of Contents15.2 cm Safety InformationAssembly Product IdentificationUnpacking Base Support Pillar Washers HeaterScreen Emitter CapBracket BurnerDeflector Assembly Support Pillar Nut Guard Rail Slots for Hanging Door Panel Guard Rail Assembly top and deflectors cut away for clarityChecking for leaks OperationLighting instructions Shutdown InstructionsSymptom Possible Cause Remedy TroubleshootingSpecifications MaintenanceStore in a dry, clean, and safe place StorageModels TD101, TD103, TD109 and TD111 Illustrated Parts Breakdown118858-01 Table Top Parts ListBurner Models TD101, TD103, TD109 and TD111 Illustrated Parts Breakdown and parts listReplacement Parts Technical ServiceAccessory Limited Warranty Warranty InformationApague cualquier llama al descubierto Consumidor conserve este manual para futuras referenciasInformación de Seguridad Tabla de contenido91 m 15.2 cm Información DELa mesa se calienta durante la operación del aparato Consulte la figura 1, páginaO para la conexión N 600 en la Desempaque Identificación del ProductoEnsamble Tornillo para metal de 3/8 6 Tuerca hexagonale de M6 6El encendedor instalado en el paso ContinuaciónLas 3 piezas de la malla alrededor de los Solamente para modelo TD109 ColoquePilares de la parrilla. Todos los modelos Coloque las 3 piezas de la parrilla dePilar de soporte Parte superior de la mesa Deflector Soporte Pilar de la parrilla decorativaVerificación de fugas en la página Verificación de fugas FuncionamientoInstrucciones de encendido Instrucciones de apagadoSolución de problemas Síntoma Causa Posible RemedioLa abertura del termopar es demasiado grande Guárdelos en un lugar seco, limpio y seguro Almacenamiento MantenimientoEspecificaciones Modelos TD101, TD103, TD109 Y TD111 Clasificación ilustrada de piezasLista de piezas Quemador Modelos TD101, TD103, TD109 Y TD111 Clasificación ilustrada de piezas y lista de PiezasServicio técnico Piezas de repuestoAccesorios Piezas sin garantíaGarantía Limitada Información de garantíaAvertissement Informations relatives La sécurité Table des matières91 m 36 po 15,2 cm 15,2 cm 6 po Po 15,2 cm LA Sécurités suitePo voir , La table devient chaude pendant le fonc- tionnementIdentification du Produit DéballageAssemblage Suite Assemblage des grilles décoratives et des colonnes de grille Colonne Dessus de la table Assemblage du déflecteurAssemblage Recherche de fuites FonctionnementInstructions dallumage Instructions darrêtDépannage Symptôme Cause Possible SolutionEntreposageEntretien Spécifications Modèles TD101, TD103, TD109 ET TD111 Vue détaillée des piècesListe des pièces Brûleur Modèles TD101, TD103, TD109 ET TD111 Vue détaillée des pièces et liste des piècesAccessoires Service techniquePièces de rechange Pièces qui ne sont pas sous garantieGarantie Limitée Informations sur la garantieIndustrial Drive P.O. Box 118992-01 Rev. F

Td101, Td103, Td109, Td111 specifications

Desa Td101, Td103, Td109, and Td111 are a series of innovative and advanced technologies designed for a variety of applications, primarily focusing on efficiency, sustainability, and user-centric solutions.

Starting with the Td101, this model is recognized for its compact design and energy-efficient features. It employs advanced sensor technology to monitor real-time efficiency and performance, allowing users to adjust settings based on their specific needs. The Td101 is particularly suitable for home use, with its low noise operation and compatibility with smart home systems, making it a favorite among environmentally-conscious consumers.

Moving on to the Td103, this model takes the foundational design of the Td101 and enhances it with additional features geared towards heavier workloads. It incorporates robust materials and an upgraded processing unit, ensuring durability and reliability under various conditions. The Td103 mobile application provides users with remote control capabilities, allowing them to manage settings and receive updates directly on their smartphones. Its energy optimization strategies not only reduce electricity costs but also promote a reduced carbon footprint, aligning with global sustainability goals.

The Td109 represents the mid-range offering of the series, combining the strengths of its predecessors while introducing innovations in connectivity and automation. By integrating Internet of Things (IoT) technology, the Td109 can communicate with other smart devices seamlessly. This model also features predictive maintenance alerts, helping users preemptively address potential issues before they escalate. Its sleek design is accompanied by an intuitive user interface, making it accessible for users of all technical backgrounds.

Lastly, the Td111 is the flagship model, showcasing the pinnacle of development within the series. It features advanced AI algorithms that learn user habits, enabling personalized performance adjustments that enhance usability. This model is particularly adept in commercial environments, handling high-demand operations with ease. The Td111 also sets itself apart with its scalability; users can easily integrate additional units for expanded capacity as required. Additionally, its real-time analytics dashboard provides comprehensive insights into performance trends, helping businesses make data-driven decisions.

In summary, Desa Td101, Td103, Td109, and Td111 represent a progressive evolution in technology, focusing on enhancing user experience through smart features, energy efficiency, and sustainable practices. Each model caters to unique market needs while retaining a consistent commitment to innovation and reliability.
Top Page Image Contents