DeWalt 900.37051 instruction manual Replacement Blade, Assembly

Page 5

598994-00,37051 8/9/05 10:17 AM Page 5

Maintain mower with care. Keep blade sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories.

DOUBLE INSULATION

Your Mower is DOUBLE INSULATED to give you added safety. This means that it is constructed throughout with TWO separate “layers” of electrical insulation, or one DOUBLE thickness of insulation between you and the tool’s electrical system.

Tools built with this insulation system are not intended to be grounded. As a result, your mower is equipped with a two-prong plug which permits you to use extension cords without concern for maintaining a ground connection.

NOTE: DOUBLE INSULATION does not take the place of normal safety precautions when operating this mower. The insulation system is for added protection against injury resulting from a possible electrical insulation failure within the tool.

CAUTION: Repair or replace damaged cords immediately. Use only identical Craftsman replacement parts.

POLARIZED PLUG

To reduce the risk of electric shock, this mower has a polarized plug (one blade is wider than the other). This mower must be used with a suitable polarized 2 wire or 3 wire extension cord. Polarized connections will fit together only one way. Make sure that the receptacle end of the extension cord has large and small blade slot widths. If the plug does not fit fully into the extension cord receptacle, reverse the plug. If it still does not fit, obtain a suitable extension cord. If the extension cord does not fit fully into the outlet, contact a qualified electrician to install the proper outlet. Do not change the tool plug or extension cord in any way.

EXTENSION CORDS

Double-insulated tools have 2 wire cords, and can be used with 2 wire or 3 wire extension cords. Only round jacketed extension cords should be used, and we recommend that they be listed by Underwriters Laboratories (U.L.)

WARNING: To prevent electric shock use only with an extension cord suitable for outdoor use, such as SW-A, SJOW-A, SOW-A, STW-A, STOW-A, SJW-A,

SJTW-A or SJTOW-A.

An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety, and to prevent loss of power and overheating. The smaller the gauge number of the wire, the greater the capacity of the cable; that is, 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

To determine the minimum wire size required, refer to the chart below: (Refer to your mower’s nameplate to find the Ampere Rating)

NOTE: Using any other length or rating or cord will diminish the performance and possibly the life of the electric motor.

MINIMUM GAUGE FOR CORD SETS

MINIMUM WIRE GAUGE RECOMMENDATIONS

VOLTS

25 FT.

50 FT.

100 FT.

 

16

16

14

120

A.W.G.*

A.W.G.*

A.W.G.*

* AMERICAN WIRE GAUGE

SAVE THESE INSTRUCTIONS

REPLACEMENT BLADE

The replacement blade is stock # 33243 and is available at Sears Retail Stores and Service Centers.

Stock# 33243

ASSEMBLY

CARTON CONTENTS

Mulching Mower (Shipped with Mulch Insert installed)

Grassbag

Grasscatcher frame

TO REMOVE MOWER FROM CARTON

Your mulching mower has been

completely assembled at the factory except for the Grasscatcher.

5

Image 5
Contents Form No AUG. ‘05 Convertible Mulching MowerGeneral Safety Rules Table of ContentsWarranty Preparation TrainingOperation Maintenance and Storage Assembly Replacement BladeTo Unfold Handle Grasscatcher AssemblyTo Install Grasscatcher Know Your Mulching Mower Meets Cpsc Safety RequirementsOperation Operator Presence Control Switch To Adjust Cutting HeightTo Stop Mower Attaching Extension Cord to MowerMowing Tips Safety Shield & Rear DoorMowing Procedure Mulching To Install Mulch InsertMulching Mowing Tips To Remove Mulch InsertTo Replace Blade To Remove BladeTo Sharpen Blade To sharpen bladeMaintenance Schedule MaintenanceGeneral Recommendations LubricationStorage Service and AdjustmentsTroubleshooting Chart Problem Cause Correction Diagram Parts Garantia ContenidoOperacion EntrenamientoPreparacion Doble Aislamiento Mantenimiento Y AlmacenajeCalibre Minimo Para Extensiones Para Pasto Instalacion DE LA BolsaEnsamblaje DE LA Bolsa Para Pasto Cumple CON LOS Requerimientos DE Seguridad Cpsc OperacionConozca SU Podadora Interruptor DE Control CON Presencia DEL Operador Union DE LA Extension AL Cordon Electrico DE LA PodadoraAjuste DE Altura DE Corte Recomendaciones DE Podado Cubierta DE Seguridad Puerta TraseraProcedimientos DE Podado Recomendaciones Para Podado CON Recorte RecorteRemocion DEL Inserto DE Recorte Instalacion DEL Inserto RecortadorAfilado de la cuchilla Remocion DE LA CuchillaCambio DE LA Cuchilla Cuadro DE Responsabilidades DEL Usuario MantenimientoAlmacenaje Servicio Y AjustesTabla Para Solucion DE Problemas Frecuentes Causa Correccion Diagram Parts 598994-00,37051 8/9/05 1017 AM 598994-00,37051 8/9/05 1017 AM