Chicago Electric 68316 owner manual 8in, Cutting Techniques

Page 14

Cutting Techniques

SETUP

OPERATION

MAINTENANCE

Rectangular Pipe

Feed blade from corner to corner.

Pipes

Feed blade through object until it reaches lower edge, keeping blade at 90º angle.

Thin Plate

Feed blade down about 3/8″ and start cut.

U-Section

Feed blade from corner to corner (where opposite corner would be).

Flat Bar Iron

Feed blade at a 90º angle to the work surface.

		REV 11h
Page 14	For technical questions, please call 1-800-444-3353.	SKU 68316

Image 14

Contents Save this Manual Work area safety Table of ContentsGeneral Power Tool Safety Warnings Electrical safetySafety Personal safetyPower tool use and care Safety Setup Operation Maintenance ServiceCircular Saw Safety Warnings Circular Saw Safety Warnings Vibration Safety Extension Cords SymbologyDouble Insulated Tools Tools with Two Prong Plugs GroundingSpecifications AssemblySafety Setup Operation Setup Before UseFunctions Tool Set Up Blade Installation Operating InstructionsSetup Operation Maintenance Operation Maintenance Using Lubrication UnitWork Piece and Work Area Set Up General Operating Instructions Feed Speed8in Cutting TechniquesShaped Plate Cleaning, Maintenance, and Lubrication Maintenance and ServicingTroubleshooting Problem Possible Causes Likely SolutionsParts List Parts List and DiagramAssembly Diagram Limited 90 Day Warranty