SAFETY
SETUP
Using Lubrication Unit
1. The blades for the Double Cut Saw are | 2. To use Lubrication Unit, use cutter paste |
“dry cut” teeth. This mean the blades only | that is in rod form which can be inserted |
need to be lubricated in extreme cutting | into the center of the Lubrication Unit. |
situations, such as when cutting aluminum, |
|
copper, stainless steel and cast iron. |
|
3. Once paste rod is inserted, turn the Lubrication Unit’s feeder wheel.
Work Piece and Work Area Set Up
OPERATION
MAINTENANCE
1.Wooden work piece selection:
a.Work piece must be free of foreign objects and loose knots.
b.Do not use to cut logs, tree limbs, or uneven lumber.
c.Wet lumber, green (unseasoned) lumber, and pressure treated lumber all have an increased potential for kickback and should only be cut with a blade designed for cutting that lumber. Wear a
2.Designate a work area that is clean and well‑lit. The work area must not allow access by children or pets to prevent distraction and injury.
3.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
4.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.
5.Verify that there are no utility lines or hardware in or near the workpiece. This is especially critical for plunge cuts.
Page 12 | For technical questions, please call | SKU 68316 |