Setup
3. Setup
AC Power
AC Plug
The Legend™ 412 Series has an
Make sure that you are connecting this product to the proper voltage. To determine the power requirements for the Legend™ 412 Series, refer to the specification label affixed to the product or the specifications in this manual.
Always connect this product to a protected circuit with an appropriate electrical ground to avoid the risk of electrocution or fire.
The listed current rating indicates the maximum current draw during normal operation. For more information, download Sizing the Circuit Breakers from www.chauvetpro.com.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
The Legend™ 412 Series should be used with a power input cord terminated with an IEC connector on one end and an Edison plug on the other end (U.S. market). Use the table below to wire a new plug if needed.
Connection | Wire (U.S.) | Wire (Europe) | Screw Color |
AC Live | Black | Brown | Yellow or Brass |
AC Neutral | White | Blue | Silver |
AC Ground | Green/Yellow | Green/Yellow | Green |
|
|
|
|
Make sure to disconnect the product’s power cord before replacing a blown fuse, and always replace it with a fuse of the same type and rating.
Fuse Replacement | This product uses a T 3.15 A, 250 V fuse. | |||
| 1. | Disconnect the product from the power outlet. | ||
| 2. | Using a flat head screwdriver, wedge the tip into the slot of the fuse holder. | ||
| 3. | Pry the safety cap out of the housing to pull out the installed fuse. | ||
| 4. | Remove the blown fuse from the safety cap and replace with a fuse of the exact same | ||
|
| type and rating (T 3.15 A, 250 V). | ||
| 5. | Insert the fuse holder back in place and reconnect power. | ||
|
|
|
| Installed fuse |
|
|
|
| |
|
|
|
| (held by plastic clip) |
|
|
|
| Safety cap |
|
|
|
| |
|
| Spare fusel |
|
|
|
|
|
| |
|
| (inside safety cap) |
|
|
This product ships with a spare fuse inside the safety cap, as shown above.
Legend™ 412 Series User Manual Rev. 5 |