Operation
DMX Control
Static Color
Auto Programs
In this mode, each product will respond to a unique starting address from the DMX controller. All products with the same starting address will respond in unison.
1.Select a DMX personality as shown in the DMX Personality section.
2.Set the starting address:
a.Go to Addr and press <ENTER>.
b.Select the starting address (001~512).
The highest recommended starting address for each DMX mode are as follows:
Legend™ 412 | Legend™ 412 VW | ||
DMX Mode | DMX Address | DMX Mode | DMX Address |
Advanced | 485 | Advanced | 493 |
Basic | 501 | Basic | 503 |
The Static mode allows for permanent positioning, strobing, dimming, and RGBW or VW color mixing without a DMX controller.
1.Go to NAnu and press <ENTER>.
2.Select the desired position (Pan or tILt).
3.Select the desired position value (0~255).
4.Repeat for the other position.
5.Select the desired color based on the product.
•Legend™ 412:
Red1~4, Gre1~4, bLu1~4, or UhI1~4.
•Legend™ 412 VW: UU1~4, or CU1~4.
6.Select the desired color value (0~255).
7.Repeat for the other colors.
8.Select the desired intensity (dINN).
9.Select the desired intensity value (0~255).
10.Select Strobe effect (Stro).
11.Select the desired frequency (0~255).
Auto programs allow for dynamic RGBW (Legend™ 412) or VW (Legend™ 412 VW) color mixing without a DMX controller.
1.Go to Shnd and press <ENTER>.
2.Select the desired auto program (Sh 1~4).
You cannot edit any of the auto programs (Sh 1~4).
Legend™ 412 Series User Manual Rev. 5 |