Footswitch Operation
The included footswitch provides quick access to the preset colors, color change programs, and triggering via the onboard microphone on the 4BAR™ Flex:
1.Power on the fixture.
2.Connect the footswitch to the 4BAR™ Flex via the
3.Press pedal #1 (Preset) to activate control. When this is operating properly, the LEDs on the 4BAR™ Flex will light white (first function on pedal #1).
Pedal |
| Function | |
| 1 x press | White | |
|
|
| |
| 2 x press | Red | |
| 3 x press | Green | |
|
|
| |
| 4 x press | Blue | |
|
|
| |
1 | 5 x press | Yellow | |
|
| ||
(Preset) | 6 x press | Magenta | |
| 7 x press | Cyan | |
|
|
| |
| 8 x press | Color change every second in a | |
| continuous loop | ||
|
| ||
| 9 x press | Color change every three seconds in a | |
| continuous loop | ||
|
| ||
2 | 1 x press | Sound controlled | |
(Sound On) | |||
|
| ||
3 | 1 x press | All LEDs off (blackout) | |
(Blackout) | |||
|
|
Disconnecting the Footswitch
There is no need to modify any settings for the 4BAR™ Flex before connecting the footswitch. It will operate properly in any mode.
Plug the master fixture in LAST!
In order to properly disconnect the footswitch, please follow these steps:
1.Unplug the footswitch from the 4BAR™ Flex.
2.Turn the power to the fixture off (unplug the power cable).
3.Turn the power to the fixture on again (plug in the power cable), and the fixture will properly operate on any one of the three modes.
4BAR™ Flex User Manual (Rev. 3) | Page 13 of 17 |