UPPER AND LOWER GLASS parts
| HALOGEN BULB | UPPER |
|
| 100 Watt |
| |
| GLASS |
| |
|
|
| |
GLASS SHADE |
| SHADE | UPPER GLASS |
|
| SHADE BRACKET | |
|
|
| |
| INCANDESCENT BULB |
| (3) |
|
|
| |
|
|
|
INSTALLING THE upper glass shade
IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the bottom styrofoam packaging from the box. After removing the top half of the styrofoam, take the bottom half from the box and place it on the floor. Take out all parts from the bottom foam and place the fan back in the form fitted recess.
UPPER
GLASS
SHADE
BRACKET
Step 5. Carefully place the upper glass shade on the foam covered brackets. Assure the glass sits evenly on the bracets and is centered.
Step 6. Take the three upper glass shade brackets and place them in the holders as shown. Using the supplied screws, tight- en a few turns on each bracket until all three are in place. DO NOT TIGHTEN COMPLETELY.
Step 7. Rotate the tightening of the brackets until all are snug.
DO NOT OVERTIGHTEN.
UPPER
GLASS
SHADE
NOTE: Make a note of the Fan Serial Number and Model Type before install- ing the top cover.
FOAM COVERED
BRACKET
fan motor
assembly
WARNING!
DO NOT USE AN ELECTRIC SCREWDRIVER AS
YOU MAY ACCIDENTALLY OVETIGHTEN THE
BRACKETS AND CAUSE THE GLASS TO BREAK.
INSTALLING THE upper glass shade
Step 8. Istall the three
Note: Use 3 maximum
6