Blade Holder Hardware

BLADE SCREW	flat WASHER
(4 PER BLADE)	(4 per blade)

CENTER STYLE BLADE HOLDER & BLADE

Step 14. Blade Installation

Attach the blades to the blade holders with four blade screws and four steel washers provided for each blade.

Hand tighten securely.

BLADE SCREW (4 PER BLADE)

flat WASHER (4 PER BLADE)

	HALOGEN BULB
GLASS SHADE	100 Watt

Installing the Halogen bulb

Step 15. Screw the 100 Watt Halogen bulb into the socket. Do not touch the glass bulb with your fingers–it is extremely important that the glass be clean. If it is touched, or dirty, clean carefully with a tissue. A dirty glass bulb will cause the bulb to fail almost immediately.

IMPORTANT! When installing the halogen bulb, care- fully cut off the end of the plastic sleeve the bulb comes in and hold the bulb by the plastic sleeve to screw it into the socket.

HALOGEN BULB

100 Watt

installing the glass shade

Step 16. Position the indentations in the outer rim of the

glass shade so that they line up with the tabs on the insidetabs surface of the fan light fixture rim.

Step 17. Carefully lift the glass shade up inside the light fixture as far as it will go.

Step 18. Rotate the shade in a clockwise direction until it is held tightly in place by the three tabs.

TIP: At first the shade is a very loose fit in the fix- ture and can be ‘wiggled’ a little from side to side. It is a great help when rotating the glass shade to ‘wiggle’ it at the same time.

glass shade indentation

light fixture

glass shade