3. Editing
Editing other effects
Press the select switch for the desired effect to be edited. MOD: Edits the Modulation effect (e.g., chorus) PEDAL: Edits the Pedal effect (e.g., wah)
AMB: Edits the Ambience effect (e.g., delay)
CABI: Edits the Cabinet effect which models the cabinet resonances of a guitar amp
NR LEV: Edits the noise reduction and program level (volume)
For some effects, the Modulation and Pedal effects, or the Pedal and Ambience effects cannot be used simultaneously. In the case of such a combination of effects, attempting to turn on both si- multaneously will automatically turn off the
As an example, here's how to select CHORUS as the Modula- tion effect.
1.Press the MOD switch. The LED beside it will blink, indicat- ing that the Modulation effect is selected.
Even if the Modulation effect has been turned off within the program, it will be turned on at this point.
2.Rotate value knob 1 (TYPE) to select CHORUS. The type name will appear in the
3.Value knobs 2, 3, 4 and 5 will adjust the chorus speed (SPEED), chorus depth (DEPTH), chorus feedback amount (FEED- BACK), and the mix balance between the chorus sound and the direct sound (MIX). If the adjusted value matches the un- edited value (the original parameter value) as you rotate a knob, the Original icon will appear in the
The value knobs that can be used and the parameters that are assigned will depend on the type of each effect. (See p.12 "Effect parameters.")
Using the TAP switch to edit the delay time
When using the Ambience or Pedal DELAY effect, press the TAP switch two times at the tempo of the song you are playing. The AX100G will detect the interval, and set the delay time auto- matically.
You can set the delay time in the same way even while you are not playing.
Modifying the program name
Press the NR LEV switch so that the LED beside the switch is blink. Use value knob 2 to select the character that you wish to change (the character will blink), and use value knob 1 to change the character. The available characters are shown below.
Available characters
If you wish to save the modified program name, you must per- form the “Writing programs” operation. If you turn off the power or select a different program without writing the program, the program name you edited will revert to its previous setting.
Writing programs
Here’s how to write an edited program.
1. | Press the WRITE switch, and the |
| “✳WRITE✳.” The number LED will blink. |
2. Use the UP and DOWN switches to select the destination for | |
| your program. |
3. | Press the WRITE switch once again, and the display will read |
| “COMPLT” to indicate that the program has been written. You |
Select | SPEED | ||||||
Modulation | |||||||
effect type |
| DEPTH | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FEEDBACK |
MIX |
MOD switch |
will then return to Program mode. |
If you decide not to write, press the EXIT switch to cancel the Write operation.
If you write an edited program to a different program number, the program that was overwritten will be lost.
It is not possible to write to a preset program.
Parameter Original icon 
10