Front and rear panel, Front panel, Rear panel

1. Introduction

Front and rear panel

Front panel

8WRITE, EXIT, TAP switches

The WRITE switch is used to write an edited program.

By pressing the EXIT switch, you can return to Program mode at any time.

When using a delay effect, you can press the TAP switch at the tempo of the song to set the delay time automatically.

9DOWN, UP switches

These switches are used to select programs, bypass or mute, or to switch the drive amp channel.

0Expression pedal

This controls the effect that is selected as the Pedal effect. After advancing the pedal all the way, you can press the pedal more firmly to switch the Pedal effect on/off.

1Type knob

This knob selects the type of Drive Amp effect that will be used.

2Value knobs

For each effect, these knobs adjust the values of the param- eters assigned to the knobs. From the left, these are referred to as value knobs 1—5.

When you are not editing an effect, parameters of the drive amp effect used by the selected program are assigned to these knobs. (Refer to p.9 "Drive Amp effect Quick Edit function.")

3Select switches

Each time you press the DRIVE·AMP switch, the drive amp channels A and B will alternate, and will be in Edit mode. At this time, the LED beside the switch will change between blink- ing green (channel A) and blinking red (channel B).

Each time you press the MOD, PEDAL, AMB, or CABI switch, the corresponding effect will be in edit mode (on) or off. The LED beside the corresponding switch will also change between blinking (lit) and dark.

Each time you press the NR LEV switch, you will alternate between editing and on. The LED beside the switch will change between blinking and dark.

Each time you press the RHYTHM or PHRASE TRAINER switch, the corresponding function will be switched on/off. The LED beside the corresponding switch will light or go dark.

4Pedal indicator

This shows the state of the pedal effect (the depth to which it is pressed). When the tuner is operating, this shows the amount of pitch deviation. In Phrase Trainer mode, this shows the re- cording/playback time.

5PROG/FX SELECT switch

Each time you press this switch, you will alternate between Program mode and Effect Select mode.

6Multi-display

This displays information such as program names, parameter names and values, and editing icons.

7Number LED

This displays the program bank and program number. While the Tuner is operating, it displays the note name.

Rear panel

1INPUT jack

If you are using batteries, this jack acts as a power switch. When a cable is connected, the power will be turned on.

Before turning the power on or off, be sure to turn down the volume of any equipment that is connected.

2Input level switch

Set this switch according to the output of your instrument.

3AUX IN jack (stereo mini)

Connect the output (AUX OUT: analog) of your audio device to this jack.

4DC9V

The separately sold AC adapter (DC9V ) can be con- nected here. When this is connected, the power will be turned on automatically.

5Cable hook

If the separately sold AC adapter is con- nected, hook the cable of the AC adapter around this hook as shown below. When removing the cable from the hook, do not apply tension.

6MASTER VOL. (Master volume)

This adjusts the volume of the OUTPUT jack.

7OUTPUT jack

This also functions as the headphone jack.

8Cable guide

This prevents the cable that connects the guitar to the AX100G from inter- fering with the operation of the pedal. Pass the cable through the guide as shown in the diagram below.

When using the cable guide, please use a cable whose diameter is 8 mm or less.

Max.

8mm