The modes of the AX100G
The AX100G is divided into three modes: Program mode, Effect
Select mode, and Phrase Trainer mode.
Program mode
In this mode you can select programs and use the AX100G for normal performance.
Use the foot switches (UP, DOWN) to select programs. Immediately after the power is turned on, the AX100G will al- ways be in this mode. With the factory settings, the User pro- grams contain the same programs as the Preset programs.
Effect Select mode
In this mode you can use the foot switches UP or DOWN to switch the drive amp channel*1, Modulation effect or Ambience effect on/off.
Programs cannot be selected in this mode. Use Program mode to select programs.
*1 The AX100G provides two (A and B) Drive (distortion) Amp Effects so that you can switch between settings such as backing and solo without having to change programs.
Phrase Trainer mode
This mode allows you to record a phrase from a CD or MD con- nected to the AUX IN jack, and play it back as a repeated loop that you can practice along with.
Since you can slow down the playback speed without affecting the pitch, this is a convenient way to learn or practice difficult phrases.
When you enter Phrase Trainer mode, the Modulation, Pedal, and Ambience effects will be turned off automatically.
In Program mode and Effect Select mode, you can use the various knobs to edit the effect, adjust noise reduction, adjust the program level, and change the program name.
Installing the batteries
1.Lightly press on arrow A of the battery case, and slide the lid upward in the direction of the arrow to open the case.
2.Insert four AA alkaline batteries (sold separately) as shown in the diagram. Be careful to observe the correct polarity (+ and
3.Close the lid of the battery case.
If you will not be using the unit for an extended period of time, remove the batteries to prevent them from leaking.
When the
2. Playing the AX100G
Example connections
The power must be off when making connections. Otherwise, dam- age to your speaker system, or other malfunctions may occur. Connecting cables are sold separately.
Headphone (*1) | Audio system |
|
Stereo 1/4" jack – stereo RCA (phone jack)
Hard disk recorder etc.
Mono output – mono 1/4" jack / stereo output - two mono 1/4" jacks
Guitar amp / powered monitor(*1)
Mono 1/4" jack – mono 1/4" jack
Guitar
AC adapter (*2)
to AC outlet
Mono 1/4" jack – mono 1/4" jack
*1: The OUTPUT jack is a stereo output. If you use a mono cable to connect the AX100G to a guitar amp, only the L (left) side signal will be output to the amp.
*2: If you use batteries, the AC adapter is not necessary. If you use an AC adapter, be sure to use only the specified
model (DC 9V 
).
Turn on the power
The AX100G does not have a power switch.
The power will be turned on when one of the following occurs.
◆If you are using batteries, the power will be turned on when you connect a mono cable to the INPUT jack. To maximize the battery life, disconnect the cable from the INPUT jack when you are not using the AX100G.
If you connect a stereo cable, the power will not be turned on.
◆If you are using the AC adapter (sold separately), the power will be turned on when you connect the AC adapter to a DC 9V.
Before you turn off the power of the AX100G, turn off the power of the other connected equipment.
2. Playing the AX100G
5