Bush Hog SM 60 manual Important Safety Precautions

Page 6

IMPORTANT SAFETY PRECAUTIONS

This symbol is used to call attention to safe- ty precautions that should be followed by the operator to avoid accidents. When you see this symbol, carefully read the message that follows and heed its advice. Failure to comply with safety precautions could result in serious bodily injury.

In addition to the design and configuration of equipment, hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training of personnel in the operation, transport, maintenance and storage of equipment. Lack of attention to safety can result in accident, per- sonal injury, reduction of efficiency and worst of all—loss of life. Watch for safety hazards and correct defi- ciencies promptly. Use the following safety precautions as a general guide to safe operations when using this machine. Additional safety precautions are used throughout this manual for specific operating and maintenance procedures. Read this manual and review the safety precautions often until you know the limitations.

1.Read the Operator’s Manual. Failure to read the Operator’s Manual is considered a misuse of this equipment.

2.Become familiar with all the machine’s controls and all the caution, warning and danger decals affixed to the machine before attempting to start or operate.

3.Before starting or operating the machine, make a walk around inspection and check for obvious

defects such as loose mounting bolts and damaged components. Correct any deficiency before starting.

4.Do not allow children to operate the cutter. Do not allow adults to operate it without proper instruction.

5.Do not carry passengers.

6.Keep the area of operation clear of all persons, particularly small children and pets. The operator should cease mowing whenever anyone comes within the operating area.

7.Clear the work area of objects which might be picked up and thrown.

8.Wear eye protection and use a piece of cardboard or wood rather than hands to search for hydraulic leaks. Escaping hydraulic oil under pressure can penetrate skin. If fluid is injected into the skin, it must be surgically removed within a few hours by a doctor familiar with this form of injury or gangrene may result.

9.Do not operate without all guards and shields in place and in good condition.

10.Stop PTO, lower implement to ground, place tractor transmission in neutral or park, set parking brake, stop tractor engine, remove ignition key and wait for all motion to completely stop before leaving the tractor.

11.Keep hands and feet away from blades.

12.This cutter is not to be operated along highways or in any area where people may be present unless all sides of the unit are enclosed by permanent bands, safety chains or other factory approved safety shields that are in good repair.

13.Wear personal protective equipment such as, but not limited to, protection for eyes, ears, feet, hands and head when operating or repairing the equipment. Do not wear loose clothing or jewelry that may catch on equipment moving parts.

14.When performing adjustments or maintenance on the cutter, first lower it to the ground or block it securely at a workable height.

15.Never stand between tractor and cutter while tractor is being backed to the cutter hitch.

16.Reduce speed when transporting cutter to avoid bouncing and momentary loss of steering.

17.Use tractor flashing warning lights, day or night, when transporting cutter on road or highways unless prohibited by law.

18.In the event that someone other than yourself will operate this equipment we firmly suggest that all SAFETY references be discussed prior to operation.

19.It is recommended that tractor be equipped with Rollover Protective System (ROPS) or ROPS enclosed cab and seat belt.

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Bush HOG Congratulations Table of Contents Retail CUSTOMER’S Responsibility Under the Bush HOG WarrantyThis Limited Warranty Shall not Apply Disclaimer of Implied Warranties & Consequential DamagesDealer Preparation Check List SM60 Rotary CutterImportant Safety Precautions Important Safety Precautions This Act Seeks EMPLOYERS, Employees and OperationsEmployee Tractor Operating Instructions Osha RegulationsSection IntroductionDescription Mounting Cutter on Tractor For Cast Iron Pump & Motor OnlySM160R Driveline Modification Tractor Requirements and Recommendations OperationRecommendations Reversing Blade Rotation ParkingStorage Maintenance Check ListMaintenance Check List Lubrication Refer to FigRecommended Hydraulic Oils YearlyCable Adjustment Blade Holder InstallationBlade Replacement Adjusting Hydraulic PressureTroubleshooting List of Recommended Hydraulic Oils ManufacturerGeneral Troubleshooting Trouble Probable Cause RemedySection Assembly Basic Machine Assembly Hydraulic Valve KitOptional Safety Chain Installation Belting InstallationOptional Sidewheel Installation Optional Tailwheel Installation AdjustmentSafety Decals 83374 83373 83377 82617 83375 Torque Specifications Recommended Torque in Foot Pounds Newton Meters

SM 60 specifications

The Bush Hog SM 60 is a versatile and durable rotary mower designed primarily for use in agricultural and landscaping applications. Known for its robust construction and exceptional performance, this machine is ideal for managing grass, brush, and overgrown vegetation, making it a valuable asset for farmers, ranchers, and landowners alike.

One of the main features of the Bush Hog SM 60 is its cutting width, which measures 60 inches. This allows for efficient mowing of large areas, reducing the time spent on maintenance tasks. The mower is equipped with a heavy-duty gearbox that provides reliable power transmission while enhancing its overall durability. This ensures that the SM 60 can handle tough mowing conditions with ease.

The design of the Bush Hog SM 60 incorporates a sturdy frame made from high-quality materials, which provides stability and strength. The mower is built to withstand harsh environments and frequent use, ensuring long-lasting performance. Additionally, the SM 60 features a reinforced deck that helps to prevent soil buildup and maintains clean, efficient cutting.

Technologically, the Bush Hog SM 60 is equipped with a set of three high-lift blades that are designed for superior cutting performance. These blades facilitate efficient grass distribution, resulting in a clean cut that promotes healthy regrowth. Furthermore, the blade design reduces the risk of clumping, which is especially crucial in wet conditions.

Another noteworthy characteristic of the SM 60 is its adjustable cutting height. Users can easily modify the height of the mower to achieve the desired level of cut, providing flexibility for different mowing conditions and types of vegetation. This feature is particularly beneficial when transitioning between various terrains, ensuring optimal performance no matter the situation.

The Bush Hog SM 60 is designed to be compatible with a variety of tractors, making it a versatile tool for any operator. Its ease of attachment and operation allows users to quickly switch from one implement to another, enhancing overall productivity.

In summary, the Bush Hog SM 60 is a powerful rotary mower that combines durability with efficiency. Its impressive features, including a wide cutting deck, robust construction, and high-performance blades, make it an exceptional choice for anyone in need of a reliable mowing solution. Whether it's for maintaining pastureland, managing brush, or enhancing landscape aesthetics, the Bush Hog SM 60 stands out as a top-tier option in the rotary mower market.
Top Page Image Contents