Bush Hog Estate Series manual Neutral Adjustment, Control Lever Adjustment

Page 17

5. CLEANING GRASS BUILD UP UNDER DECK

Depress the deck lift foot pedal and lock in position, then move the height adjustment pin to the 4-1/2” position.

Lift the front of the unit and support unit securely.

Clean out any grass build up from underside of deck and in deck discharge chute.

NEUTRAL ADJUSTMENT

1.Stop engine and remove ignition key.

2.Tilt seat forward.

3.Move the control lever rearward and release the control lever. This control lever should return to a position where the control lever can be swung outward and lock in the neutral outward position. This setting is fixed and not adjustable. If the handles do not return to neutral, contact a servicing dealer.

MOTION CONTROL NEUTRAL ADJUSTMENT

The steering has been factory adjusted to eliminate creeping when the control levers are in neutral posi- tion. However, should the mower begin to creep, adjustments can be made as outlined below. Before considering any adjustment, check the tire pressure and make certain hydraulic system oil is at operating temperature. Unequal tire pressure can cause the mower to drift to one side ( see recommended tire pressure).

1.Raise the drive wheels of the zero turn off the ground. Safely block the frame in this position so it is secure. This adjustment must be made with the drive wheels free to turn.

2.Remove the electrical connection from the seat switch and temporarily install a jumper wire across the terminals of the wiring harness.

3.Loosen the jamnuts on the vertical turnbuckles, which connect the lever control arms to the hydrostatic component control arms. Note: The nuts at the top of the turnbuckles have left- handed threads.

4.Start the engine. Release the parking brake and throttle up the engine to full throttle.

5.Observe which direction the wheels are rotating. If the wheels are rotating forward, rotate the verti- cal turnbuckle clockwise to shorten the steering control linkage until the wheel(s) come to a stop. Repeat for the opposite side if necessary.

(Note: The right hand linkage controls the right hydrostatic component and the left handle con- trols the left hydrostatic component)

6.If the wheels are rotating in reverse, then rotate the vertical turnbuckle counter-clockwise to lengthen the steering control linkage until the wheel(s) come to a stop. Repeat for the opposite side if necessary.

7.When both wheels remain in neutral, tighten the jam nuts to lock the vertical turnbuckle in place.

8.Test again by moving the control levers forward and backward before returning them to the neu- tral position. If the tires are in neutral, the unit is now ready for operation.

9.Shut the unit off. Remove the jumper wire from the wiring harness and replace the connectors into the seat switch. Never operate the mower unless all safety switches are operating properly.

CONTROL LEVER ADJUSTMENT

The control levers can be adjusted for operator com- fort. Loosen the hex head cap screws that attach the upper control lever to the lower control lever. The upper control lever can be pivoted to fit the operator’s personal preference. The control levers should be adjusted so they align with each other when in the neutral position. The upper levers can also be adjusted vertically for operator comfort. Note: The upper control levers were shipped in the highest position from the factory to allow for optional seats with armrests. If your unit does not have seat armrests, and you would prefer a lower height, then remove the hex head screws from each upper han- dle and lower to the lower position. Reinstall hard- ware and securely tighten.

Control Lever

CAUTION

TO AVOID POSSIBLE INJURY:

WHEN ADJUSTING VERTICAL TURN- BUCKLE, KEEP HANDS AND TOOLS CLEAR OF SPINNING FAN BLADES.

Pivot Bolt (3/8 x 1-1/2” w/Locknut)

Slotted Hole and Adjusting Bolt

(3/8 x 1-1/2” w/Flatwasher

and Locknut)

Cooling Fan

Vertical

Turnbuckle

Hydrostatic

Transaxle

15

Image 17
Contents Bush HOG Congratulations Retail CUSTOMER’S Responsibility Under the Bush HOG Warranty Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplyEstate Series Zero Turn Rider Dealer Preparation Check ListYour Safety is Involved Safety Alert SymbolAccident Patterns to Avoid Important Safety PrecautionsSafety Instructions and Recommendations Never Carry Passengers Do not USE Mower When Grass is WET or Slippery Description Section Introduction and DescriptionIntroduction Deck Specifications Tractor SpecificationsControls Operator Interlock SystemPRE-OPERATION Checklist General SafetySection Operation OperationOperation on Slopes Cutting Height AdjustmentANTI-SCALP Roller Adjustment Mowing Recommendations Maintenance Schedule Section MaintenanceHr break-in Grease blade spindles every 50 hours Important Substitution of an improper filter will causeEngine BatteryTires Mower BladesCleaning Grass Build UP Under Deck Neutral AdjustmentControl Lever Adjustment Deck Belt Diagram Deck Belt ReplacementHydrostatic Transaxle Motion Drive Belt Replacement Hydrostatic Transaxle Belt Tension AdjustmentSTART-UP Maintenance Fluid Volume and LevelParking Brake Adjustment Purging ProceduresTroubleshooting Check List Section IV Assembly 50043277 50012615 Safety DecalsTo Avoid Serious Injury or Death 94131 50043279 50043280 Recommended Torque in Foot Pounds Newton Meters Torque SpecificationsBush HOG, L.L.C

Estate Series specifications

Bush Hog Estate Series is an impressive lineup of versatile and durable lawn and garden equipment designed to cater to a variety of landscaping tasks. Recognized for their robust performance, these machines are built with homeowners and professionals in mind who require reliable and efficient tools for yard maintenance and improvement.

One of the standout features of the Estate Series is its powerful engine options, providing ample horsepower to handle various conditions and terrains. Whether you're tackling tough grass, dense brush, or uneven ground, the efficient engines ensure that users experience consistent performance. Moreover, the series often comes equipped with reliable hydraulic systems that improve lifting and towing capabilities, which are essential for managing heavy loads and attachments.

The build quality of the Bush Hog Estate Series is another major highlight. Constructed with high-grade materials, these machines offer great resilience against wear and tear, ensuring they can withstand the rigors of everyday use. The heavy-duty frames and reinforced structures contribute to the longevity of the machinery, making it a smart investment for both homeowner and professional use.

Ease of use is a core principle embedded in the design of the Estate Series. Many models come with intuitive controls that facilitate effortless operation, allowing users to focus on their tasks without being hindered by complicated machinery. Additionally, features such as adjustable cutting heights and easy-to-maneuver designs make these tools adaptable for various landscaping projects.

Safety is also prioritized in the Bush Hog Estate Series. With features such as roll-over protection systems and secure operator platforms, users can confidently operate these machines. The design minimizes potential hazards, making it easier for users to focus on their tasks without unnecessary risk.

One cannot overlook the innovative technologies integrated within the Estate Series. The machines often incorporate advanced drive systems that enhance traction and maneuverability, crucial for maintaining stability in challenging terrains. Furthermore, some models may include options for GPS guidance systems, enabling precision in landscaping and mowing tasks.

In summary, the Bush Hog Estate Series stands out due to its powerful performance, durable construction, user-friendly operation, and enhanced safety features. The combination of these characteristics and advanced technologies makes it an excellent choice for anyone looking to invest in reliable lawn care equipment. With the Bush Hog Estate Series, achieving a well-maintained lawn and garden has never been easier.