Bush Hog ATH 720, FTH 600 manual Dealer Preparation Check List ATH / FTH Finishing Mowers

Page 5

DEALER PREPARATION CHECK LIST

ATH / FTH FINISHING MOWERS

BEFORE DELIVERING MACHINE — The following check list should be completed. Use the Operator’s Manual as a guide.

o1. Assembly completed.

o2. Gearboxes filled with oil.

o3. All fittings lubricated.

o4. All shields in place and in good condition.

o5. All fasteners torqued to specifications given in Torque Chart r 6. All decals in place and readable. (See decal page.)

o7. Overall condition good (i.e. paint, welds)

o8. Operators manual has been delivered to owner and he has been instructed on the safe and proper use of the cutter.

o9. Warranty information has been filed online with Bush Hog.

Dealer’s

Signature

THIS CHECKLIST TO REMAIN IN OWNER’S MANUAL

It is the responsibility of the dealer to complete the procedures listed

above before delivery of this implement to the customer.

3

Image 5
Contents Bush HOG Congratulations ATH / FTHOperator’sFINISHINGManual Mower Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplyDealer Preparation Check List ATH / FTH Finishing Mowers Important Safety Precautions Rops EMPLOYERS, Employees and OperationsEmployee Tractor Operating Instructions Description Section Introduction and DescriptionIntroduction Attaching to Tractor Section Preparation for USEFlex-Link Tractor Top Link Lower Lift Arm Lower Link III Operating Instructions General SafetyCutting Height Adjustment Maintenance Check List Section MaintenanceAfter Each USE HoursBelt Replacement Belt AdjustmentFTH 480 Belt Diagram Front Belt Installation GuideTroubleshooting Blade ReplacementProblem Probable Cause Remedy Wear Heav Work Gloves to PRO Tect Hands from Sharp EdgesSection Dealer AssemblyBase Unit Assembly FTH Models ATH ModelsShut OFF Tractor ENGINE, Remove KEY, Secure Safety DecalsSAE Grade Dashes Torque SpecificationsPage Griffin Ave. Selma, AL