Blount 853PRO manual Reference, Approximate Cutting Rates, INCH-FOOT Definition

Page 14

853PRO OPERATOR’S MANUAL	REFERENCE

APPROXIMATE CUTTING RATES

Material	Cutting Rate

Concrete – 6 in (15 cm)	5 lineal in/min (12 cm/min)

Red Brick – 6 in (15 cm)	10 lineal in/min (25 cm/min)

Rebar – #4 (12 mm)	10–20 seconds through each piece

INCH-FOOT DEFINITION

An in-ft is a measure of how much material is to be cut.

An in-ft is defined as: depth in inches times length in feet.

Note: 129 in-ft = 1 m2

Example: How many in-ft are in this doorway?

1.Determine the depth of the cut in inches. For this example, 8 inches.

2.Determine the length of the cut in feet. 3+7+3+7=20 feet

3.Multiply the two numbers 8 in x 20 ft = 160 in-ft

© 2008 ICS, Blount International Inc. Specifications are subject to change without notice. REV0708 F/N 71904

15

Image 14

Contents 853PRO Hydraulic Saw Table of Contents 853PRO OPERATOR’S ManualSymbols & Labels 853PRO OPERATOR’S Manual Safety Following Symbol Applies to ALL the Items Listed on thisGeneral Safety Precautions Safety 853PRO OPERATOR’S ManualFollowing Symbol Applies to ALL Items Listed on this Technical specifications Guide BAR and Diamond Chain Installation Install the bar clamp plate over the bar studs Planning the CUT PRE-CUT ChecklistOperation 853PRO OPERATOR’S Manual Operation Cutting TipsMaintenance 853PRO OPERATOR’S Manual System CLEAN-UPDrive Sprocket Installation 853PRO OPERATOR’S Manual Drive Sprocket RemovalTroubleshooting 853PRO OPERATOR’S Manual TroubleshootingINCH-FOOT Definition ReferenceApproximate Cutting Rates Reference 853PRO OPERATOR’S Manual Performance Loss VS. Hydraulic Hose Length AssumptionsPage 853PRO Operators Manual