OPERATION | 853PRO OPERATOR’S MANUAL |
|
|
PRE-CUT CHECKLIST
•Proper Diamond Chain Tension: The diamond chain should be tight but easily pulled around the guide bar by hand.
•Ensure all safety devices are properly mounted and functional and that all controls are in proper working order.
•Be sure there are no obstructions (plumbing, electrical conduit, air ducts).
•Always wear protective clothing, including hard hat, eye protection, hearing protection,
•Adequate Water Supply and Pressure 1 gpm (4 lpm) recommended flow Minimum water pressure 20 psi (1.5 bar)
Note: The single most important factor an operator can control to increase chain life is to use adequate water pressure. Insufficient water supply will result in excessive wear to the chain, which can lead to loss of strength and chain breakage.
•Proper Hydraulic Supply to the saw
Maximum Flow 8 gpm (30 lpm) or 12 gpm (45 lpm), depending on saw model Maximum Hydraulic Pressure 2,500 psi (172.5 bar)
PLANNING THE CUT
•Outline the cut with a permanent marker for a visual cutting guide.
•Avoid pinching the guide bar and diamond chain. Always cut the bottom of an opening first, then top, and then the sides. Save the easiest cut for last.
•For the straightest cuts use the “Step Cut” method. First score the entire cut line approximately a 1/2 inch (12 mm) deep using the nose of the guide bar. Next, deepen the cut by about 2 inches (50 mm). Then plunge all the way through and complete the cut using the WallWalker®.
•Be sure cut concrete cannot fall and injure operator or bystanders. Concrete is very heavy, one cubic foot = 12 in x 12 in x 12 in = 150 lbs (30 cm x 30 cm x 30 cm = 68 kg).
•Check for live electrical wiring near the cutting area or in the concrete to avoid electrocution.
10 | © 2008 ICS, Blount International Inc. Specifications are subject to change without notice. REV0708 F/N 71904 |