Blount 853PRO manual Guide BAR and Diamond Chain Installation

Page 7

Set-UP	853PRO OPERATOR’S MANUAL

GUIDE BAR AND DIAMOND CHAIN INSTALLATION

STEP 1

Loosen the side cover nuts and remove the side cover.

STEP 4

Mount the chain on the bar starting at the drive sprocket & continue over the bar nose.

Install the chain correctly. The bumper must always lead the segment into the cut as shown here.

STEP 2

Place the bar onto the studs and the chain adjustment pin.

STEP 3

Turn the chain-tensioning screw CCW until the bar comes into contact with the drive sprocket.

STEP 5

Make sure all of the drive links are inside the bar groove, then pre- tension the chain.

8	© 2008 ICS, Blount International Inc. Specifications are subject to change without notice. REV0708 F/N 71904

Image 7

Contents 853PRO Hydraulic Saw 853PRO OPERATOR’S Manual Table of ContentsSymbols & Labels 853PRO OPERATOR’S Manual Following Symbol Applies to ALL the Items Listed on this SafetyFollowing Symbol Applies to ALL Items Listed on this Safety 853PRO OPERATOR’S ManualGeneral Safety Precautions Technical specifications Guide BAR and Diamond Chain Installation Install the bar clamp plate over the bar studs Operation 853PRO OPERATOR’S Manual PRE-CUT ChecklistPlanning the CUT Cutting Tips OperationSystem CLEAN-UP Maintenance 853PRO OPERATOR’S Manual853PRO OPERATOR’S Manual Drive Sprocket Removal Drive Sprocket InstallationTroubleshooting Troubleshooting 853PRO OPERATOR’S ManualApproximate Cutting Rates ReferenceINCH-FOOT Definition Performance Loss VS. Hydraulic Hose Length Assumptions Reference 853PRO OPERATOR’S ManualPage 853PRO Operators Manual