Loading the CD Changer
1Press 3 CDC to select CD mode.
2Press OPEN•CLOSE.
ª The CD carousel slides out.
3Load a CD with the printed side up in the right tray.
•You can load another disc in the left tray.
•To load the third disc, press the DISC CHANGE button.
ªThe CD carousel will rotate until the empty tray is ready for loading.
4Press OPEN•CLOSE to close the CD carousel.
ªThe total number of tracks and the playing time of the last selected disc appear on the display.
Note:
–To ensure good system performance, wait until the CD changer completely reads the disc(s) before proceeding.
CD Direct Play
You can play a CD directly by pressing the DISC 1, DISC 2 or DISC 3 button. The CD player will stop at the end of playback of the selected disc.
–A lit button indicates that a disc is loaded in the disc tray.
Playing a CD
1Press PLAYƒto start playback.
ªThe disc tray, track number and elapsed playing time of the current
track appear on the display.
•To interrupt playback, press•. ª The playing time flashes.
•To resume playback, press PLAYƒ again.
2To stop playback, press STOP.
Note:
–All the available discs will play once, then stop.
Disc Change
You can change the outer two discs while the third inner disc is stopped or is playing.
1Press DISC CHANGE.
ª The CD carousel slides out.
2Replace the discs in the left and right disc trays.
•If you press DISC CHANGE again during playback, the CD will stop playing.
ªThe CD carousel will rotate until the inner tray is rotated out and is ready for loading.
3Press OPEN•CLOSE to close the CD compartment.
Selecting a desired track
Selecting a desired track when playback is stopped
1Press S or T (or ’/ ‘on the remote control) until the desired track appears on the display.
2Press PLAYƒto start playback.
ªThe selected track number and elapsed playing time appear on the display.
Selecting a desired track during playback
•Press S or T (less than 0.5 seconds) until the desired track appears on the display.
ªThe selected track number and elapsed playing time appear on the display.
•If you press S (less than 0.5 seconds) it will skip to the beginning of the current track and play the track again.
Searching for a particular passage during playback
•Press and hold SEARCH S or T (or ˆ/ ‡on the remote control) until the desired passage is located.
ª The volume will be reduced.
•Play returns to normal when SEARCH S or T is released.
CD
Programming Tracks
Programming tracks of a loaded CD is possible when playback is stopped. The display will indicate the total tracks stored in the program. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show “FULL”.
1Load the desired discs in the disc trays.
2Press PROGRAM to start programming.
ªThe PROGRAM flag starts flashing.
ªIt will cancel any previously selected repeat mode.
3Press the 3 CDC button to select the disc.
4Press S or T (or ’/ ‘on the remote control) to select the desired track.
5Press PROGRAM to store the track.
•Repeat steps 3 to 5 to store other discs and tracks.
6Press STOP once to end programming.
ªThe total number of tracks programmed and total playing time appear on the display.
Notes:
–If the total playing time is more than
“99:59“ or if one of the programmed tracks has a number greater than 30, then
English
17